M45PE10-VMN6TP Micron Technology Inc, M45PE10-VMN6TP Datasheet - Page 10

• Manufacturer Part Number: M45PE10-VMN6TP
• Manufacturer: Micron Technology Inc

Specifications of M45PE10-VMN6TP

• Cell Type: NOR
• Density: 1Mb
• Access Time (max): 8ns
• Interface Type: Serial (SPI)
• Boot Type: Not Required
• Address Bus: 1b
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: -40C to 85C
• Package Type: SOIC N
• Sync/async: Synchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 128K
• Supply Current: 8mA
• Mounting: Surface Mount
• Pin Count: 8
• Lead Free Status / Rohs Status: Compliant

SPI modes
3
10/47
SPI modes
These devices can be driven by a microcontroller with its SPI peripheral running in either of
the two following modes:
For these two modes, input data is latched in on the rising edge of Serial Clock (C), and
output data is available from the falling edge of Serial Clock (C).
The difference between the two modes, as shown in
bus master is in standby mode and not transferring data:
Figure 3.
1. The Write Protect (W) signal should be driven, High or Low as appropriate.
Figure 3
device is selected at a time, so only one device drives the serial data output (Q) line at a
time, the other devices are high impedance.
The pull-up resistor R (represented in
master leaves the S line in the high impedance state.
In applications where the bus master might enter a state where all inputs/outputs SPI lines
are in high impedance at the same time (for example, if the bus master is reset during the
transmission of an instruction), the Clock line (C) must be connected to an external pull-
down resistor so that, if all inputs/outputs become high impedance, the C line is pulled Low
(while the S line is pulled High). This ensures that S and C do not become High at the same
time, and so, that the t
SPI interface with
(CPOL, CPHA) =
CS3
(0, 0) or (1, 1)
SPI bus master
CPOL=0, CPHA=0
CPOL=1, CPHA=1
C remains at 0 for (CPOL=0, CPHA=0)
C remains at 1 for (CPOL=1, CPHA=1)
CS2 CS1
shows an example of three devices connected to an MCU, on an SPI bus. Only one
Bus master and memory devices on the SPI bus
SDO
SDI
SCK
R
SHCH
R
requirement is met.
C Q D
S
SPI memory
device
W
Figure
V
CC
Reset
V
R
3) ensures that no device is selected if the bus
SS
C Q D
S
Figure
SPI memory
device
W
4, is the clock polarity when the
V
Reset
CC
R
V
SS
C Q D
S
SPI memory
device
W
M45PE10
V
CC
Reset
AI12836c
V
SS
V
V
CC
SS