166981-005 FCI, 166981-005 Datasheet - Page 22

• Manufacturer Part Number: 166981-005
• Manufacturer: FCI

Specifications of 166981-005

• Lead Free Status / Rohs Status: Not Compliant

TITLE
Specification of Requirements for Cable Preparation, Wire Termination and
Copyright FCI
Form E-3334
Rev E
12.6
Assembly of Connectors Using 72392-type Contacts
The contact must be fully seated so that the latch finger snaps into the locking window and holds the
contact in place. The following figure shows the visual inspection needed to determine that the contact is
properly latched in the insulator.
The following figure demonstrates the visual inspection procedure to check that the contact is properly
aligned in the insulator. This visual inspection requires the aid of at least a 10x magnification lens. The
reason the shown defect is named a “blackeye’ is that it prevents light from passing through from the IDC
side of the insulator to the pin window side. On a good contact, insertion light can pass through the
contact tip gap.
Wires Inserted in Wrong Position or Defective Insertion
12.6.1 Preferred Method of Repair
The preferred method of repair is to cutoff the defective connector sub-assemblies from the cable
just above the connectors, strip the end of the cable and insert the wires into new connector sub-
assemblies.
Figure 20 Checking for Proper Contact Latching After Insertion
Figure 21 Checking for Damaged Terminal After Insertion
TYPE
APPLICATION SPECIFICATION
PDM: Rev:J
NUMBER
PAGE
AUTHORIZED BY
STATUS
STATUS:
J.R. Volstorf
22 of 29
UNRESTRICTED
Released
GS-20-002
REVISION
DATE
25-Apr-06
Printed: Nov 27, 2010
J
GS-01-001
.