MB91F376G Fujitsu Components, MB91F376G Datasheet - Page 161

• Manufacturer Part Number: MB91F376G
• Manufacturer: Fujitsu Components

Specifications of MB91F376G

• Lead Free Status / Rohs Status: Not Compliant

19. 400 kHz I
(1) Features
This section describes the functions and operation of the fast I
The I
• Master/slave transmitting and receiving functions
• Arbitration function
• Clock synchronization function
• General call addressing support
• Transfer direction detection function
• Repeated start condition generation and detection function
• Bus error detection function
• 7 bit addressing as master and slave
• 10 bit addressing as master and slave
• Possibility to give the interface a seven and a ten bit slave address
• Acknowledging upon slave address reception can be disabled (Master-only operation)
• Address masking to give interface several slave addresses (in 7 and 10 bit mode)
• Up to 400 KBit transfer rate
• Possibility to use built-in noise filters for SDA and SCL
• Can receive data at 400 KBit if R-bus-Clock is higher than 6 MHz regardless of prescaler setting
• Can generate MCU interrupts on transmission and bus error events
• Supports being slowed down by a slave on bit and byte level
The I
if the R-bus-Clock (CLKP) is higher than 6 MHz regardless of the prescaler setting. However, clock stretching
on byte level is performed since SCL is pulled low during an interrupt (INT = “1” in IBCR register) .
2
2
C interface is a serial I/O port supporting the Inter IC bus, operating as a master/slave device on the I
C interface does not support SCL clock stretching on bit level since it can receive the full 400 KBit datarate
2
C Interface
2
C interface.
MB91360G Series
2
C bus.
161