AT86RF211-DAI Atmel, AT86RF211-DAI Datasheet - Page 15

• Manufacturer Part Number: AT86RF211-DAI
• Manufacturer: Atmel

Specifications of AT86RF211-DAI

• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Modulation Type: FSK
• Product Depth (mm): 7mm
• Product Length (mm): 7mm
• Operating Supply Voltage (typ): 2.5/3.3V
• Lead Free Status / Rohs Status: Not Compliant

RSSI Output
Figure 18. Typical RSSI output (board implementation, T = 25°C, V
Note:
1942C–WIRE–06/02
Should the RSSI be required for accurate measurement purpose (precision better than 5 dB), then it is possible to measure one
value with a calibrated RF source and store it into the microcontroller, during the production testing.
70
60
50
40
30
20
10
0
-110
-100
The RSSI value can be read as a 6 bits word in the STATUS register. Its value is linear
in dB as plotted below:
The RSSI dynamic range is 50 dB from -95 dBm to -45 dBm RF input signal power, over
temperature and power supply ranges. The RSSI LSB’s value weighs about 1.3 dB in
the linear area. The RSSI value is measured from the IF2 chain.
The RSSI is periodically measured thanks to a successive approximation ADC with a
12 µs clock. Thereafter, the time needed to complete the right code depends on the
power step: a 10 dB step on the aerial leads to a 10/1.3 = 8 clock cycles, i.e. 96 µs (full
range from code 0 to 63 = 756 µs). Its value can be compared with a user predefined
value (TRSSI), so that the demodulated data is enabled only if the RSSI value is above
this threshold. Some hysteresis effect may be added (see CTRL1 register’s content).
The AT86RF211 also has the possibility to measure another voltage. The ADC measur-
ing the RSSI can be turned into voltage or discriminator output DC level measurement.
Dispersion: +/-5dB
-90
Power Level at Antenna Input Port (dBm)
-80
Dynam ic Range: 50dB
RSSI Output
-70
CC
= 3V)
-60
-50
-40
AT86RF211
-30
15