SC16C2550IB48,151 NXP Semiconductors, SC16C2550IB48,151 Datasheet - Page 27

• Manufacturer Part Number: SC16C2550IB48,151
• Description: IC UART DUAL W/FIFO 48-LQFP
• Manufacturer: NXP Semiconductors

Specifications of SC16C2550IB48,151

• Features: 2 Channels
• Number Of Channels: 2, DUART
• Fifo's: 16 Byte
• Voltage - Supply: 3.5 V ~ 4.5 V
• With Auto Flow Control: Yes
• With Irda Encoder/decoder: Yes
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• With Cmos: Yes
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-3261; 935270020151; SC16C2550IB48-S

Philips Semiconductors
9397 750 11621
Product data
7.10 Enhanced Feature Register (EFR)
7.9 Scratchpad Register (SPR)
Table 19:
[1]
The SC16C2550 provides a temporary data register to store 8 bits of user
information.
Enhanced features are enabled or disabled using this register.
Bits 0 through 4 provide single or dual character software flow control selection.
When the Xon1 and Xon2 and/or Xoff1 and Xoff2 modes are selected, the double
8-bit words are concatenated into two sequential numbers.
Table 20:
Bit
1
0
Bit
7
6
Whenever any MSR bit 0-3 is set to logic 1, a Modem Status Interrupt will be generated.
Symbol
EFR[7]
EFR[6]
Modem Status Register bits description
Enhanced Feature Register bits description
Symbol
MSR[1]
MSR[0]
Dual UART with 16 bytes of transmit and receive FIFOs and IrDA
Description
Automatic CTS flow control.
Automatic RTS flow control. Automatic RTS may be used for hardware flow
control by enabling EFR[6]. When Auto-RTS is selected, an interrupt will
be generated when the receive FIFO is filled to the programmed trigger
level and RTS will go to a logic 1 at the next trigger level. RTS will return to
a logic 0 when data is unloaded below the next lower trigger level
(programmed trigger level 1). The state of this register bit changes with the
status of the hardware flow control. RTS functions normally when
hardware flow control is disabled.
Rev. 03 — 19 June 2003
Logic 0 = Automatic CTS flow control is disabled (normal default
condition).
Logic 1 = Enable Automatic CTS flow control. Transmission will stop
when CTS goes to a logical 1. Transmission will resume when the CTS
pin returns to a logical 0.
0 = Automatic RTS flow control is disabled (normal default condition).
1 = Enable Automatic RTS flow control.
Description
DSR
CTS
Logic 0 = No DSR change (normal default condition).
Logic 1 = The DSR input to the SC16C2550 has changed state
since the last time it was read. A modem Status Interrupt will be
generated.
Logic 0 = No CTS change (normal default condition).
Logic 1 = The CTS input to the SC16C2550 has changed state
since the last time it was read. A modem Status Interrupt will be
generated.
[1]
[1]
…continued
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
SC16C2550
encoder/decoder
27 of 46