AT32UC3B1512 Atmel Corporation, AT32UC3B1512 Datasheet - Page 244

• Manufacturer Part Number: AT32UC3B1512
• Manufacturer: Atmel Corporation

Specifications of AT32UC3B1512

• Flash (kbytes): 512 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 60 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 28
• Ext Interrupts: 28
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 16
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

19.13.8
Figure 19-31. Read Write Flowchart in Slave Mode
32059L–AVR32–01/2012
2. TXCOMP is only set at the end of the transmission because after the repeated start, SADR is detected again.
Read Write Flowcharts
SADR + MSDIS + SVEN
Set the SLAVE mode:
Read Status Register
EOSACC = 1 ?
TXCOMP = 1 ?
SVACC = 1 ?
END
The flowchart shown in
in Slave mode. A polling or interrupt method can be used to check the status bits. The interrupt
method requires that the interrupt enable register (IER) be configured first.
GACC = 1 ?
Figure 19-31 on page 244
programming sequence
Read TWI_RHR
SVREAD = 0 ?
RXRDY= 0 ?
Decoding of the
Change SADR
Prog seq
OK ?
gives an example of read and write operations
GENERAL CALL TREATMENT
Write in TWI_THR
TXRDY= 1 ?
244