AD9879 Analog Devices, AD9879 Datasheet - Page 29
![no-image](/images/manufacturer_photos/0/0/56/analog_devices_sml.jpg)
AD9879
Manufacturer Part Number
AD9879
Description
Mixed Signal Front End Set Top Box, Cable Modem (MxFE®)
Manufacturer
Analog Devices
Datasheet
1.AD9879.pdf
(32 pages)
Specifications of AD9879
Resolution (bits)
12bit
# Chan
5
Sample Rate
29MSPS
Interface
Par
Analog Input Type
Diff-Uni
Ain Range
2 V p-p
Adc Architecture
Pipelined
Pkg Type
QFP
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AD9879BS
Manufacturer:
ADI/亚德诺
Quantity:
20 000
Company:
Part Number:
AD9879BS BSZ
Manufacturer:
AD
Quantity:
1 045
Company:
Part Number:
AD9879BSZ
Manufacturer:
ADI
Quantity:
330
Company:
Part Number:
AD9879BSZ
Manufacturer:
Analog Devices Inc
Quantity:
10 000
Part Number:
AD9879BSZ
Manufacturer:
ADI/亚德诺
Quantity:
20 000
GROUND PLANES
In general, if the component placing guidelines discussed in the
Component Placement section can be implemented, it is best to
have at least one continuous ground plane for the entire board.
All ground connections should be made as short as possible.
This results in the lowest impedance return paths and the
quietest ground connections.
If the components cannot be placed in a manner that keeps the
high frequency ground currents from traversing under the
MxFE and analog components, it may be necessary to put
current steering channels into the ground plane to route the
high frequency currents around these sensitive areas. These
current steering channels should be made only when and where
necessary.
Rev. A | Page 29 of 32
SIGNAL ROUTING
The digital Rx and Tx signal paths should be kept as short as
possible. Also, these traces should have a controlled impedance
of about 50 Ω. This prevents poor signal integrity and the high
currents that can occur during undershoot or overshoot caused
by ringing. If the signal traces cannot be kept shorter than
approximately 1.5 inches, then series termination resistors
(33 Ω to 47 Ω) should be placed close to all signal sources. It is
advisable to series terminate all clock signals at their source
regardless of trace length.
The receive (I IN, Q IN, and RF IN) signals are the most
sensitive signals on the entire board. Careful routing of these
signals is essential for good receive path performance. The Rx±
signals form a differential pair and should be routed together as
a pair. By keeping the traces adjacent to each other, noise
coupled onto the signals appears as common-mode and is
largely rejected by the MxFE receive input. Keeping the driving
point impedance of the receive signal low and placing any low-
pass filtering of the signals close to the MxFE further reduces
the possibility of noise corrupting these signals.
AD9879