TMPM380FWFG Toshiba, TMPM380FWFG Datasheet - Page 111

• Manufacturer Part Number: TMPM380FWFG
• Manufacturer: Toshiba

Specifications of TMPM380FWFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 12K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 2
• I2c/sio (ch): 2
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 18
• 16-bit Timer / Counter: 8
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

7 Exceptions
Be sure to set active state of the Standby clear request, in case the interrupt is enabled for clearing the
Standby modes.
(Note 1) When using interrupts, be sure to follow the sequence of actions shown below:
(Note 2) Each settings must be performed while interrupts are disabled.
(Note 3) For clearing the Standby modes , 18 interrupt factors (INT0 to INTF,INTRTC,INTRMCRX) are
(Note 4) In case the standby mode clear is not required, interrupt factors (INT0 to INTF,INTRTC,INTRMCRX)
available. CGIMCGA~CGIMCGE Resisters in CG are used for selecting edge/level of active state
and which aforementioned factors are used for clearing the standby modes.
can be used as a normal interrupt without setting CGIMCGA~CGIMCGE Resisters in CG.
1) If the external intrrupt request pin shared with other general ports, enable the port to receive the
interrupt.
2) Set conditions such as active state upon initialization.
3) Clear interrupt requests.
4) Enable interrupts.
TMPM380/M382 - 56 / 59 -
TMPM380/M382