TLE 6389-2G V50 Infineon Technologies, TLE 6389-2G V50 Datasheet - Page 4
![no-image](/images/manufacturer_photos/0/3/327/infineon_technologies_sml.jpg)
TLE 6389-2G V50
Manufacturer Part Number
TLE 6389-2G V50
Description
Manufacturer
Infineon Technologies
Datasheet
1.TLE_6389-2GV.pdf
(38 pages)
Specifications of TLE 6389-2G V50
Packages
PG-DSO-14
Comment
Vin up to 60V; external MOS
Vq (max)
5.0V
Iq (max)
2,300.0 mA
Iq (typ)
130.0 µA
Output
Buck Converter
Datasheet Rev. 2.1
1.5
Pin No
1
1
2
3
4
5
6
7
8
9
Symbol
ENABLE Active-High enable input (only at adjustable version, TLE6389-2 GV)
SI_ENA
BLE
FB
VOUT
GND
SYNC
SI_GND
SI
COMP
SO
Pin Definitions and Functions
Function
for the device.
The device is shut down when ENABLE is driven low. In this shut down-
mode the reference, the output and the external MOSFET are turned off.
Connect to logic high for normal operation.
Active-High enable input (only at 5V version, TLE6389-2 GV50 and
TLE6389-3 GV50) for SI_GND input.
SI_GND is switched to high impedance when SI_ENABLE is low. High
level at SI_ENABLE connects SI_GND to GND with low impedance. SO is
undefined when SI_ENABLE is low.
Feedback input.
1. For adjustable version (-2GV) connect this pin to an external voltage
divider from the output to GND (see the determining the output voltage,
application section).
2. At the 5V fixed output voltage version (-3GV50 and -2GV50) the FB is
connected internally to an on-chip voltage divider. It does not have to be
connected externally to the output.
Buck output voltage input.
Input for the internal supply. Connect always to the output of the buck
converter (output capacitor).
Ground connection. Analog signal ground.
Input for external frequency synchronization.
An external clock signal connected to this pin allows switching frequency
synchronization of the device. The internal oscillator is clocked then by the
frequency applied at the SYNC input.
SI-Ground input.
Ground connection for SI comparator resistor divider. Depending on
SI_ENABLE this input is switched to high impedance or low ohmic to GND.
Sense comparator input.
Input of the low-battery comparator. This input is compared to an internal
1.25V reference where SO gives the result of the comparison. Can be
used for any comparison, not necessarily as battery sense.
Compensation input.
Connect via RC-compensation network to GND.
Sense comparator output.
Open drain output from SI comparator at the adjustable version (TLE6389-
2 GV),
Pull down structure with an internal 20k pull up resistor to VOUT at the
5V version (TLE6389-2 GV50 and TLE6389-3 GV50).
4
TLE 6389
2007-08-13