M25P80 Numonyx, B.V., M25P80 Datasheet - Page 32
![no-image](/images/no-image-200.jpg)
M25P80
Manufacturer Part Number
M25P80
Description
8 Mbit, low voltage, serial Flash memory with 75 MHz SPI bus interface
Manufacturer
Numonyx, B.V.
Datasheet
1.M25P80.pdf
(52 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
M25P80-UMW6TG
Manufacturer:
ST
Quantity:
20 000
Part Number:
M25P80-VMN6P
Manufacturer:
MICRON
Quantity:
20 000
Part Number:
M25P80-VMN6PBA
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
M25P80-VMN6TP
Manufacturer:
Numonyx
Quantity:
22 500
Company:
Part Number:
M25P80-VMN6TP
Manufacturer:
MICRON44
Quantity:
2 163
Instructions
6.11
32/52
Deep Power-down (DP)
Executing the Deep Power-down (DP) instruction is the only way to put the device in the
lowest consumption mode (the Deep Power-down mode). It can also be used as an extra
software protection mechanism, while the device is not in active use, since in this mode, the
device ignores all Write, Program and Erase instructions.
Driving Chip Select (S) High deselects the device, and puts the device in the Standby mode
(if there is no internal cycle currently in progress). But this mode is not the Deep Power-
down mode. The Deep Power-down mode can only be entered by executing the Deep
Power-down (DP) instruction, to reduce the standby current (from I
in
Once the device has entered the Deep Power-down mode, all instructions are ignored
except the Release from Deep Power-down and Read Electronic Signature (RES)
instruction. This releases the device from this mode. The Release from Deep Power-down
and Read Electronic Signature (RES) instruction also allows the Electronic Signature of the
device to be output on Serial Data Output (Q).
The Deep Power-down mode automatically stops at Power-down, and the device always
Powers-up in the Standby mode.
The Deep Power-down (DP) instruction is entered by driving Chip Select (S) Low, followed
by the instruction code on Serial Data Input (D). Chip Select (S) must be driven Low for the
entire duration of the sequence.
The instruction sequence is shown in
Chip Select (S) must be driven High after the eighth bit of the instruction code has been
latched in, otherwise the Deep Power-down (DP) instruction is not executed. As soon as
Chip Select (S) is driven High, it requires a delay of t
to I
Any Deep Power-down (DP) instruction, while an Erase, Program or Write cycle is in
progress, is rejected without having any effects on the cycle that is in progress.
Figure 17. Deep Power-down (DP) instruction sequence
Table
S
C
D
CC2
and the Deep Power-down mode is entered.
14).
0
1
2
Instruction
3
4
5
6
Figure
7
17.
DP
Stand-by Mode
t
DP
before the supply current is reduced
CC1
Deep Power-down Mode
to I
CC2
, as specified
M25P80
AI03753D