RLZS-1608 Roithner LaserTechnik GmbH, RLZS-1608 Datasheet - Page 3

• Manufacturer Part Number: RLZS-1608
• Description: Znse White Led
• Manufacturer: Roithner LaserTechnik GmbH

Note)
4 RELIABILITY
Note)
5 CAUTIONS
・ Store at room temperature (25±3℃) and under low humidity (RH lower than 50%).
・ Static electricity or surge voltage damages the LEDs. It is recommended to use a wristband or
・ Reflow soldering should be performed at the peak temperature under 240℃ and less than 10
・ Hand repair soldering should be performed at temperatures under 300℃ and less than 3
・ It is recommended to use isopropyl alcohol as a solvent for cleaning the LEDs. When using
・ Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of
4.1 Test Item and Result
4.2 Criteria For Judging The Damage
5.1 Storage
5.2 Static Electricity
5.3 Soldering Conditions
5.4 Cleaning
・ The reliability guarantee criterion is defined by MIL-S-19500H. The data shows LTPD is 15%.
Forward Voltage
Luminous Intensity
・ U.S.L.: Upper Standard Level., L.S.L: Lower Standard Level.
Care should be taken after due consideration when using LEDs.
Consecutive operating
Temperature humidity
an anti-electrostatic glove when handling the LEDs.
seconds.
seconds. (one time only)
other solvents, it should be confirmed before hand whether the solvents dissolve the resin or
not. Freon solvent should not be used to clean the LEDs because of worldwide regulations.
ultrasonic cleaning on the LEDs depends on the factors such as ultrasonic power and the
assembled condition. Before cleaning pre-test should be done to confirm will not cause any
damage to the LEDs.
storage lifetime test
storage lifetime test
High temperature
Reflow heat test
lifetime test
Test Item
Item
Symbol
Vf
Iv
If=20mA / DC, Ta=25℃, t=1,000hours
Ta=60℃, RH=90%, t=1,000hours
Test Conditions
T=240℃(Max), t=10sec.
Ta=85℃, t=1,000hours
If=20mA
If=20mA
Reflow soldering
Test Condition
L.S.L.x0.5
Criteria for Judgement
Min.
-
U.S.L.x1.1
Max.
Result
-
0/18
0/18
0/18
0/18