HN29V102414 Renesas Electronics Corporation., HN29V102414 Datasheet - Page 13

• Manufacturer Part Number: HN29V102414
• Description: 1g And Type Flash Memory More Than 32,113-sector 542,581,248-bit X 2
• Manufacturer: Renesas Electronics Corporation.

HN29V102414 Series
Mode Description
Read
Serial Read (1): Memory data D0 to D2111 in the sector of address SA is sequentially read. Output data is
not valid after the number of the SC pulse exceeds 2112. When CA is input, memory data D (m) to D (m + j)
in the sector of address SA is sequentially read. Then output data is not valid after the number of the SC pulse
exceeds (2112 to m). The mode turns back to the standby mode at any time when CE is V
.
IH
Serial Read (2): Memory data D2048 to D2111 in the sector of address SA is sequentially read. Output data
is not valid after the number of the SC pulse exceeds 64. The mode turns back to the standby mode at any
time when CE is V
.
IH
Automatic Erase
Single Sector Erase: Memory data D0 to D2111 in the sector of address SA is erased automatically by
internal control circuits. After the sector erase starts, the erasure completion can be checked through the
RDY/Busy signal and status data polling. All the bits in the sector are "1" after the erase. The sector valid
data stored in a part of memory data D2048 to D2111 must be read and kept outside of the sector before the
sector erase.
Automatic Program
Program (1): Program data PD0 to PD2111 is programmed into the sector of address SA automatically by
internal control circuits. When CA is input, program data PD (m) to PD (m + j) is programmed from CA into
the sector of address SA automatically by internal control circuits. By using program (1), data can
additionally be programed 15 times for each sector before the following erase. When the column is
programmed, the data of the column must be [FF]. After the programming starts, the program completion can
be checked through the RDY/Busy signal and status data polling. Programmed bits in the sector turn from
"1" to "0" when they are programmed. The sector valid data should be included in the program data PD2048
to PD2111.
Program (2): Program data PD0 to PD2111 is programmed into the sector of address SA automatically by
internal control circuits. After the programming starts, the program completion can be checked through the
RDY/Busy signal and status data polling. Programmed bits in the sector turn from "1" to "0" when they are
programmed. The sector must be erased before programming. The sector valid data should be included in the
program data PD2048 to PD2111.
Program (3): Program data PD2048 to PD2111 is programmed into the sector of address SA automatically
by internal control circuits. By using program (3), data can additionally be programed 15 times for each
sector befor the following erase. When the column is programmed, the data of the column must be [FF].
After the programming starts, the program completion can be checked through the RDY/Busy signal and
status data polling. Programmed bits in the sector turn from "1" to "0" when they are programmed.
11