RN470K1HBK-1016P Lelon, RN470K1HBK-1016P Datasheet - Page 7

• Manufacturer Part Number: RN470K1HBK-1016P
• Description: Specifications: Manufacturer: Lelon ; Product Category: Aluminum Electrolytic Capacitors - Leaded ; RoHS: Details ; Capacitance: 47 uF ; Tolerance: 10 % ; Voltage Rating: 50 Volts ; Operating Temperature Range: - 40 C to + 85 C ; Termination St
• Manufacturer: Lelon

No.
10 Solderability Test
11 Venting Test
12 Standards
8
9
Test
Characteristics
Test
Surge Voltage
Mechanical
Item
The capacitor shall be subjected to 1000 cycles
at 85±3℃. Protective series resistor a 1KΩ each
consisting of a charge period of 30±5 seconds,
followed by discharge period of approximately
5.5 minutes.
Applying voltage:
1. The test is about lead tabs strength.
2. Tension Test:
3. Bending Test:
After the lead wire fully immersed in the solder for 2±0.5 secs at a temperature of 245±5℃, the solder
coating must be more than 95%.
1. Applicable to the capacitors with case diameter is 6.3 mm and larger.
2. Test condition:
Note:
Satisfies Characteristic W of JIS C 5101-4
The lead tabs shall not be broken or any malformed condition after fixing capacitor vertically and
pressing the following weight on the lead tabs of capacitor for 10±1 secs.
The capacitor is held in vertical position. Attach a weight to the lead tabs, slowly rotate the capacitor
900 to a same way in the opposite direction. Repeat it again (5 secs per cycle). The lead tabs shall not
be broken or cracked.
(1) AC test
(2) DC test:
(1) When the pressure relief vent operated, the capacitor shall avoid any danger of fire or explosion of
(2) When the pressure relief device does not open with the voltage applied over 30 minutes, the test is
W. V. (V)
W. V. (V)
S. V. (V)
S. V. (V)
The capacitor shall be connected across a applying 50 or 60 Hz AC which is 0.7 times of rated voltage or
250Vrms AC whichever is the lower.
Applying inverse DC rated voltage with current to the capacitor.
Where case diameter: φD ≦ 22.4mm: 1 A DC max
φD ＞ 22.4mm: 10 A DC max
capacitor element(terminal and metal foil etc.) or cover.
considered to be passed.
6.3
63
79
8
100
125
10
13
Conditions
160
200
16
20
Lead tabs diameter(mm)
Lead tabs diameter(mm)
200
250
25
32
0.6~0.8
0.6~0.8
≦0.5
＞0.8
≦0.5
＞0.8
250
300
35
44
50
63
Capacitance
change
Leakage
Current
Physical
Tanδ
Weight(Kg)
Weight(Kg)
0.25
0.50
1.00
0.5
1.0
2.0
Within ±20% of initial value.
Less than 175% of specified value
Within specified value
No broken and undamaged
Specification
- 2 -