RN470K1HBK-1016P Lelon, RN470K1HBK-1016P Datasheet - Page 9

• Manufacturer Part Number: RN470K1HBK-1016P
• Description: Specifications: Manufacturer: Lelon ; Product Category: Aluminum Electrolytic Capacitors - Leaded ; RoHS: Details ; Capacitance: 47 uF ; Tolerance: 10 % ; Voltage Rating: 50 Volts ; Operating Temperature Range: - 40 C to + 85 C ; Termination St
• Manufacturer: Lelon

3. Maintenance Inspection
4. Storage
Periodical inspection is necessary for using the aluminum capacitors with
industrial equipment. The following items should be checked:
(1) Appearance: Vent operation, leaking electrolyte, etc.
(2) Electrical characteristic: Capacitance, dissipation factor, leakage current,
(1) Aluminum electrolytic capacitor should not be stored in high temperature
(3) Cleaning Circuit Boards After Soldering
Lelon recommend replacing the capacitors if the parts are out of
specification.
and other specified items listed in specification.
or high humidity condition. The suitable condition is 5℃ ~ 35℃ and less
than 75% in relative humidity indoor.
Halogenated solvent cleaning is not available for aluminum electrolytic
capacitors. IPA (Isopropyl Alcohol) is one of the most acceptable
cleaning agents; it is necessary to maintain a flux content in the
cleaning liquid at a maximum limit of 2 Wt. %. If you use other
cleaning agents, please consult Lelon.
(e) Defective mountiong on PCB and improper external strength
For further details, please refer to
IEC 60384-4- Fixed capacitors for use in electronic equipment – Part 4: Sectional specification – Aluminium
EIAJ RCR-2367B- Guideline of notabilia for fixed aluminium electrolytic capacitors for use in electronic equipment
(i) Good soldering.
applied on the lead wires or case body after soldering (see below
drawings) may damage inside structure of the capacitor and may
cause short circuit, high leakage current or leakage problems.
electrolytic capacitors with solid (MnO2) and non-solid electrolyte (Established in January 1995, Revised in March 2007), and
[Technical Standardization Committee on Passive Components (Established in March 1995, Revised in March 2002)].
○
(a)
╳
(b)
5. Disposal
6. Environmental Consideration
(2) Do not store the capacitors in damp conditions such as water, brine or oil.
(3) Do not store the capacitors that exposed to hazardous gas such as
(4) Do not store the capacitors that exposed to ozone, ultraviolet rays or
(5) Do not expose the capacitors to acidic or alkaline solutions.
(6) It is not applied to a regulation of JEDEC J-STD-020 (Rev. C ).
Lelon already have receivd ISO 14000 certificate. Cadmium (Cd), Lead (Pb),
Mercury (Hg), Hexavalent Chromium (Cr+6), PBB and PBDE have never
been using in capacitor. If you need “Halogen-free” products, please consult
with us.
Please consult with a local industrial waste disposal specialist when
disposing of aluminum electrolytic capacitors.
hydrogen sulfide, sulfurous acid, nitrous acid, chlorine, ammonium, etc.
radiation.
(ii) Hole-to-hole space on board differs from the lead space of lead wires.
(iii) Lead wires are bent after soldering.
(iv) Case body doesn’t stand vertical on board after soldering. Do not
bend or twist the capacitor’s body after soldering.
╳
(c)
╳
(d)
- 4 -