CDB61310 Cirrus Logic, Inc., CDB61310 Datasheet - Page 7

• Manufacturer Part Number: CDB61310
• Description: T1/e1 Line Interface Units
• Manufacturer: Cirrus Logic, Inc.

AWG RAM (see Figure 2 on page 8). Notice the six
buttons along the bottom of this window.
Modify Unit Interval brings up the Transmitter
RAM UI Config window, which allows the user to
edit the contents of the AWG registers. It is de-
scribed in the following section.
Read from File reads previously generated data
from a file.
Load to File writes the currently displayed data
into a file for later recovery using the Read from
File command.
Read from RAM reads the current data from the
AWG RAM and displays it in the current window.
DS440DB2
Figure 1. Register Configuration Window
Write to RAM writes the displayed data to the
AWG RAM. This must be done before exiting to
write the data to the device.
Exit returns control to the main CDB61310 menu.
It does not automatically write the data to the
CS61310.
10.5 Modify Unit Interval
The user modifies the data in the AWG RAM using
the Transmitter RAM UI Config window (see Fig-
ure 3 on page 9). At the top of this window are three
radio buttons used for selecting one of the three
unit intervals. At the lower right is another set of ra-
dio buttons, one for each of the prestored wave-
forms in ROM (config 2 through config f). After
having selected the desired UI and line configura-
tion, clicking on the Read button will display the
CDB61310
7