LPC2212 Philips Semiconductors (Acquired by NXP), LPC2212 Datasheet - Page 27

• Manufacturer Part Number: LPC2212
• Description: 16/32-bit Arm Microcontrollers; 128/256 KB Isp/iap Flash With 10-bit ADC And External Memory Interfacebased on a 16/32 Bit ARM7TDMI-STM Cpu With Real-time Emulation And Embedded Trace Support, Together With 128/256 Kilobytes (kB) of Embedded High Spe
• Manufacturer: Philips Semiconductors (Acquired by NXP)

Philips Semiconductors
7. Limiting values
9397 750 12747
Preliminary data
Table 9:
In accordance with the Absolute Maximum Rating System (IEC 60134).
[1]
[2]
[3]
[4]
[5]
[6]
Symbol Parameter
V
V
V
AV
V
V
I
I
T
P
stg
18
3
3A
i
i
IN
The following applies to the Limiting values:
a) Stresses above those listed under Limiting values may cause permanent damage to the device.
b) This product includes circuitry specifically designed for the protection of its internal devices from
c) Parameters are valid over operating temperature range unless otherwise specified. All voltages
Not to exceed 4.6 V.
Including voltage on outputs in 3-state mode.
Only valid when the V
The peak current is limited to 25 times the corresponding maximum current.
Dependent on package type.
This is a stress rating only and functional operation of the device at these or any conditions other
than those described in
of this specification is not implied.
the damaging effects of excessive static charge. Nonetheless, it is suggested that conventional
precautions be taken to avoid applying greater than the rated maximum.
are with respect to V
Supply voltage, internal rail
Supply voltage, external rail
Analog 3.3 V pad supply voltage
Analog input voltage on A/D related
pins
DC input voltage, 5 V tolerant I/O
pins
DC input voltage, other I/O pins
DC supply current per supply pin
DC ground current per ground pin
Storage temperature
Power dissipation (based on
package heat transfer, not device
power consumption)
Limiting values
[3][4]
Rev. 01 — 02 February 2004
16/32-bit ARM microcontrollers with external memory interface
3
supply voltage is present.
SS
unless otherwise noted.
Section 8 “Static characteristics”
[6]
[2][3]
[5]
[5]
Conditions
LPC2212/LPC2214
and
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
Section 9 “Dynamic characteristics”
Min
-
-
1.5
0.5
0.5
0.5
0.5
0.5
0.5
40
Max
+2.5
+3.6
4.6
5.1
6.0
V
100
100
125
-
3
+ 0.5 V
Unit
V
V
V
V
V
mA
mA
W
C
27 of 39