WM8955BL Wolfson Microelectronics, WM8955BL Datasheet - Page 34

• Manufacturer Part Number: WM8955BL
• Description: Stereo DAC
• Manufacturer: Wolfson Microelectronics

w
WM8955BL
POWER SUPPLIES
Figure 19 2-Wire Serial Control Interface
The WM8955BL has two possible device addresses, which can be selected using the CSB pin.
Table 25 2-Wire MPU Interface Address Selection
The WM8955BL can use up to four separate power supplies:
•
•
•
•
It is possible to use the same supply voltage on all four. However, digital and analogue supplies
should be routed and decoupled separately to keep digital switching noise out of the analogue signal
paths.
CSB STATE
AVDD / AGND: Analogue supply, powers all analogue functions except the headphone drivers.
AVDD can range from 1.8V to 3.6V and has the most significant impact on overall power
consumption (except for power consumed in the headphone). A large AVDD slightly improves
audio quality.
HPVDD / HPGND: Headphone supply, powers the headphone drivers. HPVDD is normally tied
to AVDD, but it requires separate layout and decoupling capacitors to curb harmonic distortion.
If HPVDD is lower than AVDD, the output signal may be clipped.
DCVDD: Digital core supply, powers all digital functions except the audio and control interfaces.
DCVDD can range from 1.42V to 3.6V, and has no effect on audio quality. The return path for
DCVDD is DGND, which is shared with DBVDD.
DBVDD: Digital buffer supply, powers the audio and control interface buffers. This makes it
possible to run the digital core at very low voltages, saving power, while interfacing to other
digital devices using a higher voltage. DBVDD draws much less power than DCVDD, and has
no effect on audio quality. The return path for DBVDD is DGND, which is shared with DCVDD.
High
Low
DEVICE ADDRESS
0011010
0011011
PD Rev 4.1 February 2007
Production Data
34