MB86941 Fujitsu Microelectronics, Inc., MB86941 Datasheet - Page 11

• Manufacturer Part Number: MB86941
• Description: Peripheral Lsi For Sparclite
• Manufacturer: Fujitsu Microelectronics, Inc.

4. SDTR SIGNALS (24)
DSR0#
DSR1#
RTS0#
RTS1#
DTR0#
DTR1#
CTS0#
CTS1#
TRNDT0
TRNDT1
TEMP0
TEMP1
TRDY0
TRDY1
Pin symbol
I/O
O
O
O
O
O
O
O
O
O
O
I
I
I
I
Pin no.
26
60
28
58
31
56
27
59
29
57
42
46
33
52
Data Set Ready 0
Data Set Ready 1
Request To Send 0
Request To Send 1
Data Terminal Ready 0
Data Terminal Ready 1
Clear To Send 0
Clear To Send 1
Transmit Data 0
Transmit Data 1
Transmit Empty 0
Transmit Empty 1
Transmit Ready 0
Transmit Ready 1
Pin name
Modem control signal DSR input pin
The status of these pins is indicated at the status
register bit 7.
Modem control signal RTS output pin
Set the command register bit 5 to “1” to output an “L”
signal, or to “0” to output an “H” signal.
These pins can be used as a DATA TERMINAL
READY signal or a RATE SELECT signal of
modem.Set the command register bit 1 to “1” to output
an “L” signal, or to “0” to output an “H” signal.
Modem CLEAR TO SEND pin
To enable sending, the command register bit 0 must
be set to “1” and also an “L” level signal must be input
at these pins.
Transmit Data pin
Parallel data written to the data register is converted to
serial data and output from these pins.
In asynchronous mode, a start bit and stop bit are
attached, and a parity bit may be attached if
necessary.
If there is no data to be sent in the SDTR module, in
synchronous mode a synchronizing character is output
and in asynchronous mode the pins go to mark mode.
If a send-prohibited setting (command register bit 0 set
to “0”) is in effect, or if an “H” signal is input at the
CTS# pin, these pins to mark mode. However if a
send-prohibited setting is entered while a sending
operation is in progress, all sending data already
written will be sent before these pins go to mark mode.
In addition, in bisynchronous mode if the first
synchronization character is being sent
(synchronization standby), then these pins will go to
mark mode after sending the second synchronization
character.
These pins indicate whether sending data is present.
If there is no data to be sent in the SDTR module, the
signal level is “H.”
As soon as one byte of sending data is written, these
pins go to “L” level at the fall of the write signal.
Transmit Ready output pin
When the CTS# signal is “L” and the command
register is set to enable sending, these pins send an
“H” level signal whenever the sending data buffer is
empty.
Description
MB86941/942
(Continued)
11