T315HW05 AUO, T315HW05 Datasheet - Page 30

• Manufacturer Part Number: T315HW05
• Description: LCD Module
• Manufacturer: AUO

9. PRECAUTIONS
© Copyright AUO Optronics Corp. 2009 All Rights Reserved.
Please pay attention to the followings when you use this TFT LCD module.
9-1 MOUNTING PRECAUTIONS
9-2 OPERATING PRECAUTIONS
(1) You must mount a module using holes arranged in four corners or four sides.
(2) You should consider the mounting structure so that uneven force (ex. twisted stress) is not applied
(3) Please attach the surface transparent protective plate to the surface in order to protect the polarizer.
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not desirable because the former
(6) Do not touch, push or rub the exposed polarizer with glass, tweezers or anything harder than HB
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft materials
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer causes
(9) Do not open the case because inside circuits do not have sufficient strength.
(1) The device listed in the product specification sheets was designed and manufactured for TV
(2) The spike noise causes the mis-operation of circuits. It should be lower than following voltage:
(3) Response time depends on the temperature. (In lower temperature, it becomes longer..)
(4) Brightness of CCFL depends on the temperature. (In lower temperature, it becomes lower.) And in
(5) Be careful for condensation at sudden temperature change. Condensation makes damage to
(6) When fixed patterns are displayed for a long time, remnant image is likely to occur.
to module. And the case on which a module is mounted should have sufficient strength so that
external force is not transmitted directly to the module.
Transparent protective plate should have sufficient strength in order to the resist external force.
generates corrosive gas of attacking the polarizer at high temperature and the latter cause circuit
broken by electro-chemical reaction.
pencil lead. And please do not rub with dust clothes with chemical treatment. Do not touch the
surface of polarizer for bare hand or greasy cloth. (Some cosmetics are detrimental to the polarizer.)
like chamois soaks with petroleum benzene. Normal-hexane is recommended for cleaning the
adhesives used to attach front/ rear polarizer. Do not use acetone, toluene and alcohol because
they cause chemical damage to the polarizer.
deformations and color fading.
application
V=±200mV(Over and under shoot voltage)
lower temperature, response time (required time that brightness is stable after turned on) becomes
longer.
polarizer or electrical contacted parts. And after fading condensation, smear or spot will occur.
T315HW05 V0 Product Specification
Page 30 / 31
www.DataSheet4U.net
Rev. 01