TLE6217 Infineon Technologies, TLE6217 Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/3/327/infineon_technologies_sml.jpg)
TLE6217
Manufacturer Part Number
TLE6217
Description
Smart Quad Channel Low-Side Switch
Manufacturer
Infineon Technologies
Datasheet
1.TLE6217.pdf
(20 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TLE6217G
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
www.DataSheet4U.com
This IC is especially designed to drive inductive loads (relays, electromagnetic valves).
Integrated clamp-diodes limit the output voltage when inductive loads are discharged.
Four open-drain logic outputs indicate the status of the integrated circuit. The following conditions are
monitored and signalled:
Input Circuits
The control and enable inputs, both active high, consist of schmitt triggers with hysteresis. All inputs are
provided with pull-down current sources. Not connected inputs are interpreted as low and the respective
output stages are switched off.
In standby mode (STBY = LOW) the current consumption is greatly reduced.
The circuit is active when STBY = HIGH.
If the standby function is not used, it is allowed to connect the standby pin directly to VS.
Status Signals: The status signals are undefined for 2ms after a power up event or a STBY low to high
transition.
Output Stages
The four power outputs consist of DMOS-power transistors with open drains. The output stages are
short circuit protected throughout the operating range. Each output has it's own zenerclamp. This
causes a voltage limitation at the power transistor when inductive loads are switched off.
Parallel to the DMOS transistors there are internal pull down current sources. They are provided to de-
tect an open load condition in the off state. They will be disconnected in the standby mode.
Due to EMI measures there is an internal zenerclamp in parallel to the output stage. It gets active above
33V drain source voltage. This leads to an increasing leakage current up to 1 mA @ V
Protective Circuits
The outputs are protected against current overload and overtemperature. If the output current increases
above the overload detection threshold I
above T
the input is switched off and on again.
Fault Detection
The status outputs indicate the switching state of the output stage. Under normal conditions is: ST = low
as listed in the diagnostic table.
If current overload or overtemperature occurs for a longer time than t
into an internal register and the output is shutdown. The reset is done by switching off the corresponding
control input for a time longer than t
V5
- Overloading of output (also shorted load to supply) in active mode
- Open and shorted load to ground in active and inactive mode
- Overtemperature
Output off; ST = high
th
, then the power transistor is immediately switched off. It remains off until the control signal at
Output on. If an error occurs, the logic level of the status output is inverted,
Application Description
D-IN
Circuit Description
.
Q O
P r e l i m i n a r y D a t a s h e e t T L E 6 2 1 7
Page 8 of 20
for a longer time then t
D SO
DSO
or the temperature increases
, the fault condition is latched
30. 07. 2002
DS
= 40V.