B121EW01_V5 AUO, B121EW01_V5 Datasheet - Page 5

• Manufacturer Part Number: B121EW01_V5
• Description: LCD MODULE
• Manufacturer: AUO

1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
6) Since CMOS LSI is used in this module, take care of static electricity and insure
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow
13) Small amount of materials having no flammability grade is used in the LCD module. The
14) The LCD module is designed so that the CFL in it is supplied by Limited Current
spots.
surface.
human earth when handling.
taken out from the container, do not press the center of the CCFL Reflector edge.
Instead, press at the far ends of the CFL Reflector edge softly. Otherwise the TFT
Module may be damaged.
tilt the Interface Connector of the TFT Module.
example), do not twist nor bend the TFT Module even momentary. At designing the
enclosure, it should be taken into consideration that no bending/twisting forces are
applied to the TFT Module from outside.
damaged.
local ordinances or regulations for disposal.
LCD module should be supplied by power complied with requirements of Limited Power
Source(, IEC60950 or UL1950), or be applied exemption.
Circuit(IEC60950 or UL1950). Do not connect the CFL in Hazardous Voltage Circuit.
Product Specification
Document version 0.1
Otherwise the TFT Module may be
B121EW01 V5
5/36