USB HOST DRIVER V03 Freescale Semiconductor / Motorola, USB HOST DRIVER V03 Datasheet - Page 11

• Manufacturer Part Number: USB HOST DRIVER V03
• Description: USB Host Driver v03
• Manufacturer: Freescale Semiconductor / Motorola

NOTE: The Firmware must be downloaded and started prior to Driver installation. The
installation will be initiated by the system automatically when connecting the Device to
the PC.
1.5.2.
M
1. Logon to Windows 2000 using an administrator account.
2. Ensure that the following 3 files are all contained in the Driver installation
3. Ensure that the VendorID and ProductID members of the Device descriptor on
4. Connect the Host PC with the UFTP Device running on the MCF5272
5. “Found New Hardware Wizard” dialog with string “USB Device” will appear.
6. Select the radio button labeled "Search for a suitable Driver for your Device
7. “Locate Driver Files” page will appear, click the "Next" button
8. “Insert manufacturer installation disk on the drive…” file prompt dialog will
9. “Driver Files Search Result” page should appear. If the Driver path is specified
10. Hit the "Next" button, whereupon the "copying Files" message box will be seen
11. A copy of motusb.sys should be in the %SystemRoot%\System32\Drivers
directory: motusb.sys, motusb.dll, mcf5272.inf
Device have not changed. If you have to change them, it is necessary to make a
new installation (INF) file for the VendorID and ProductID member values
combination. (See MOTUSB Driver Guide, Chapter 4 for detailed information on
the INF file).
development board via a USB cable.
Select “Next” button.
(Recommended)" and then hit the "Next" button.
appear. Specify the folder where all Driver files are located and click ok.
correctly “Windows found a Driver for this Device” and the path to mcf5272.inf
strings will be shown at the center of the page.
briefly; then once again the "Found New Hardware Wizard" box, now displaying
the subheading "Hardware Install: The hardware installation is complete". Hit the
"Finish" button.
directory, and the motusb.dll in the %SystemRoot%\System32 directory. If the
final "Add New Hardware Wizard" box indicates any error, or if the OS indicates
that a reboot is required in order to finish the installation of this Device,
something has gone wrong. Check the Inf file or Install directory, follow the
instructions again for a ‘clean’ install, and start over.
Driver installation steps.
PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE
Introduction.
1-3