B150PN01 AU, B150PN01 Datasheet - Page 3

• Manufacturer Part Number: B150PN01
• Description: TFT LCD Module
• Manufacturer: AU

www.DataSheet4U.com
0.6 2001/8/13
1.0 Handing Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
6) Since CMOS LSI is used in this module, take care of static electricity and insure human
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for example),
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local
13) Small amount of materials having no flammability grade is used in the LCD module. The LCD
(C) Copyright AU Optronics, Inc.
July, 2001 All Rights Reserved.
No Reproduction and Redistribution Allowed.
spots.
surface.
earth when handling.
taken out from the container, do not press the center of the CCFL Reflector edge. Instead,
press at the far ends of the CFL Reflector edge softly. Otherwise the TFT Module may be
damaged.
the Interface Connector of the TFT Module.
do not twist nor bend the TFT Module even momentary. At designing the enclosure, it
should be taken into consideration that no bending/twisting forces are applied to the TFT
Module from outside. Otherwise the TFT Module may be damaged.
ordinances or regulations for disposal.
module should be supplied by power complied with requirements of Limited Power Source(2.11,
IEC60950 or UL1950), or be applied exemption.
18
SEB20P-HF13
Update mechanical drawing
B150PN01 Ve r.06
HF11
change from 20
pin to 30 pin.
3/20