AN1176 STMicroelectronics, AN1176 Datasheet - Page 16

• Manufacturer Part Number: AN1176
• Description: 68HC11/PSD813F1 DESIGN GUIDE
• Manufacturer: STMicroelectronics

2.3.10 Programming with FlashLINK
Connect the FlashLINK
box in the design flow window. You should see the following window pop up:
This window allows you to describe the JTAG chain that exists on your circuit board, your
desired operation, and also offers a loop back test for your FlashLINK
use, test your FlashLINK
the ‘LoopTest’ button and follow the directions.
This design example uses a JTAG chain of one device, which is the most typical case. Now let’s
define the JTAG chain:
Now that the file and part are specified, you must specify the operation that you want to perform.
In this case we want to program the device. Notice in the highlighted blue line for device number
one in the window above, the operation is ‘ByPass’. This is the default operation for all devices
that are added to the JTAG chain. Lets change that operation by clicking the right mouse button
on the highlighted blue line.
Page 14
Specify the *.obj file to be programmed into the PSD. Click the browse button
within the ‘Chain Information’ area to find your file. In this example, it is
yourfile.obj, as shown in the window above.
Choose the device name, PSD813F1, also shown above.
Click the ‘Add’ button to add the *.obj file and the PSD device to the chain
definition as shown.
TM
TM
JTAG cable to the PC parallel port. Click the ‘JTAG Programming’
cable and PC port by clicking on the ‘HW Setup’ button, then click
TM
TM
cable. If this is your first