SSD1322 SOLOMON SYSTECH, SSD1322 Datasheet - Page 35

• Manufacturer Part Number: SSD1322
• Description: Dot Matrix High Power OLED/PLED Segment/Common Driver
• Manufacturer: SOLOMON SYSTECH

www.DataSheet.co.kr
10 COMMAND
10.1.1 Enable Gray Scale Table (00h)
This command is sent to enable the Gray Scale Table setting (command B8h).
10.1.2 Set Column Address (15h)
This triple byte command specifies column start address and end address of the display data RAM. This
command also sets the column address pointer to column start address. This pointer is used to define the
current read/write column address in graphic display data RAM. If horizontal address increment mode is
enabled by command A0h, after finishing read/write one column data, it is incremented automatically to the
next column address. Whenever the column address pointer finishes accessing the end column address, it is
reset back to start column address and the row address is incremented to the next row.
10.1.3 Write RAM Command (5Ch)
After entering this single byte command, data entries will be written into the display RAM until another
command is written. Address pointer is increased accordingly. This command must be sent before write data
into RAM.
10.1.4 Read RAM Command (5Dh)
After entering this single byte command, data is read from display RAM until another command is written.
Address pointer is increased accordingly. This command must be sent before read data from RAM.
SSD1322
Rev 0.10
P 35/56 Apr 2008
Solomon Systech
Datasheet pdf - http://www.DataSheet4U.net/