LM3S2601 Luminary Micro, Inc, LM3S2601 Datasheet - Page 32

• Manufacturer Part Number: LM3S2601
• Description: Lm3s2601 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

Architectural Overview
1.4.4.2
1.4.4.3
1.4.4.4
32
conditions. The module provides a single combined interrupt when any of the interrupts are asserted
and are unmasked.
SSI (see page 305)
Synchronous Serial Interface (SSI) is a four-wire bi-directional communications interface.
The LM3S2601 controller includes two SSI modules that provide the functionality for synchronous
serial communications with peripheral devices, and can be configured to use the Freescale SPI,
MICROWIRE, or TI synchronous serial interface frame formats. The size of the data frame is also
configurable, and can be set between 4 and 16 bits, inclusive.
Each SSI module performs serial-to-parallel conversion on data received from a peripheral device,
and parallel-to-serial conversion on data transmitted to a peripheral device. The TX and RX paths
are buffered with internal FIFOs, allowing up to eight 16-bit values to be stored independently.
Each SSI module can be configured as either a master or slave device. As a slave device, the SSI
module can also be configured to disable its output, which allows a master device to be coupled
with multiple slave devices.
Each SSI module also includes a programmable bit rate clock divider and prescaler to generate the
output serial clock derived from the SSI module's input clock. Bit rates are generated based on the
input clock and the maximum bit rate is determined by the connected peripheral.
I
The Inter-Integrated Circuit (I
(a serial data line SDA and a serial clock line SCL).
The I
devices, LCDs, tone generators, and so on. The I
diagnostic purposes in product development and manufacture.
The LM3S2601 controller includes two I
IC devices over an I
and read) data.
Devices on the I
both sending and receiving data as either a master or a slave, and also supports the simultaneous
operation as both a master and a slave. The four I
Slave Transmit, and Slave Receive.
A Stellaris
Both the I
a transmit or receive operation completes (or aborts due to an error). The I
interrupts when data has been sent or requested by a master.
Controller Area Network (see page 377)
Controller Area Network (CAN) is a multicast shared serial-bus standard for connecting electronic
control units (ECUs). CAN was specifically designed to be robust in electromagnetically noisy
environments and can utilize a differential balanced line like RS-485 or a more robust twisted-pair
wire. Originally created for automotive purposes, now it is used in many embedded control
applications (for example, industrial or medical). Bit rates up to 1Mb/s are possible at network lengths
below 40 meters. Decreased bit rates allow longer network distances (for example, 125 Kb/s at
500m).
2
C (see page 342)
2
C bus interfaces to external I
2
®
C master and slave can generate interrupts. The I
I
2
C module can operate at two speeds: Standard (100 Kbps) and Fast (400 Kbps).
2
C bus can be designated as either a master or a slave. Each I
2
C bus. The I
2
C) bus provides bi-directional data transfer through a two-wire design
2
2
C bus supports devices that can both transmit and receive (write
C devices such as serial memory (RAMs and ROMs), networking
Preliminary
2
C modules that provide the ability to communicate to other
2
2
C bus may also be used for system testing and
C modes are: Master Transmit, Master Receive,
2
C master generates interrupts when
2
C slave generates
2
C module supports
July 26, 2008