CLAA154WB03A CHUNGHWA PICTURE TUBES, CLAA154WB03A Datasheet - Page 22

• Manufacturer Part Number: CLAA154WB03A
• Description: Display Module
• Manufacturer: CHUNGHWA PICTURE TUBES

CPT
10. HANDLING PRECAUTIONS FOR TFT-LCD MODULE
10.1 ASSEMBLY PRECAUTION
10.2 OPERATING PRECAUTIONS
CPT Confidential
Please pay attention to the followings in handling- TFT-LCD products;
(1) Please use the mounting hole on the module side in installing and do not beading or wrenching
(2) Please design display housing in accordance with the following guidelines.
(3) Please do not push or scratch LCD panel surface with any-thing hard. And do not soil LCD panel
(4) Please do not press any parts on the rear side such as source TCP, gate TCP, control circuit board and
(5) Please wipe out LCD panel surface with absorbent cotton or soft clothe in case of it being soiled.
(6) Please wipe out drops of adhesives like saliva and water on LCD panel surface immediately. They
(7) Please do not take a LCD module to pieces and reconstruct it. Resolving and reconstructing modules
(8) Please do not touch metal frames with bare hands and soiled gloves. A color change of the metal
(9) Please pay attention to handling lead wire of backlight so that it is not tugged in connecting with inverter.
(1) Please be sure to turn off the power supply before connecting and disconnecting signal input cable.
(2) Please do not change variable resistance settings in LCD module. They are adjusted to the most
(3) Please consider that LCD backlight takes longer time to become stable of radiation characteristics in low
surface by touching with bare hands. ( Polarizer film, surface of LCD panel is easy to be flawed.)
FPCs during handling LCD module. If pressing rear part is unavoidable, handle the LCD module with
care not to damage them.
might damage to cause panel surface variation and color change.
may cause them not to work well.
frames can happen during a long preservation of soiled LCD modules.
suitable value. If they are changed, it might happen LCD does not satisfy the characteristics
specification.
temperature than in room temperature.
LCD in assembling. And please do not drop, bend or twist LCD module in handling.
•
• Keep sufficient clearance between LCD module back surface and housing when the LCD module is
• When some parts, such as, FPC cable and ferrite plate, are installed underneath the LCD module,
• Design the inverter location and connector position carefully so as not to give stress to lamp cable, or
• Keep sufficient clearance between LCD module and the others parts, such as inverter and speaker so
wrench module.
statically.
mounted. Approximately 1.0 mm of the clearance in the design is recommended taking into
account the tolerance of LCD module thickness and mounting structure height on the housing.
still sufficient clearance is required, such as 0.5mm. This clearance is, especially, to be reconsidered
when the additional parts are implemented for EMI countermeasure.
not to interface the LCD module by the lamp cable.
as not to interface the LCD module. Approximately 1.0mm of the clearance in the design is
recommended.
Housing case must be destined carefully so as not to put stresses on LCD all sides and not to
The stresses may cause non-uniformity even if there is no non-uniformity
22/28
www.DataSheet.net/
CHUNGHWA PICTURES TUBES, LTD.,
CLAA154WB03A-STUDIO-V1-20071214
www.yslcd.com.tw
Datasheet pdf - http://www.DataSheet4U.co.kr/