CS4272 Cirrus Logic, CS4272 Datasheet - Page 45
![no-image](/images/no-image-200.jpg)
CS4272
Manufacturer Part Number
CS4272
Description
24-Bit / 192 kHz Stereo Audio CODEC
Manufacturer
Cirrus Logic
Datasheet
1.CS4272.pdf
(53 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
CS4272-CZZ
Manufacturer:
CIRRUS
Quantity:
40
Company:
Part Number:
CS4272-CZZR
Manufacturer:
CIRRUS
Quantity:
1 560
Part Number:
CS4272-CZZR
Manufacturer:
CIRRUS
Quantity:
20 000
Company:
Part Number:
CS4272-DZ
Manufacturer:
PHI
Quantity:
2 961
Part Number:
CS4272-DZ
Manufacturer:
CIRRUSLOGIC
Quantity:
20 000
Part Number:
CS4272-DZZ
Manufacturer:
CIRRUS
Quantity:
20 000
Company:
Part Number:
CS4272-DZZR
Manufacturer:
TI
Quantity:
12
Part Number:
CS4272CZZ
Manufacturer:
CIRRUS
Quantity:
20 000
9.
Dynamic Range
Total Harmonic Distortion + Noise
Frequency Response
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
Offset Error
DS593F1
PARAMETER DEFINITIONS
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is added to resulting measurement to refer the measurement to full-scale.
This technique ensures that the distortion components are below the noise level and do not affect the
measurement. This measurement technique has been accepted by the Audio Engineering Society,
AES17-1991, and the Electronic Industries Association of Japan, EIAJ CP-307. Expressed in decibels.
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels. Measured
at -1 and -20 dBFS as suggested in AES17-1991 Annex A.
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response
at 1 kHz. Units in decibels.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with no signal to the input under test and a full-scale signal applied to the other channel. Units in
decibels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
The deviation of the mid-scale transition (111...111 to 000...000) from the ideal. Units in mV.
CS4272
45