ds90lv049h National Semiconductor Corporation, ds90lv049h Datasheet - Page 4

• Manufacturer Part Number: ds90lv049h
• Description: High Temperature 3v Lvds Dual Line Driver And Receiver Pair
• Manufacturer: National Semiconductor Corporation

www.national.com
Switching Characteristics
Note 8: t
the same device.
Note 9: t
specified differential propagation delays. This specification applies to devices at the same V
Note 10: t
going edge of the same receiver channel.
Note 11: t
Note 12: t
propagation delays. This specification applies to devices at the same V
Note 13: Generator waveform for all tests unless otherwise specified: f = 1 MHz, Z
Note 14: Output short circuit current (I
Note 15: All input voltages are for one channel unless otherwise specified. Other inputs are set to GND.
Note 16: f
switching.
Note 17: f
Parameter Measurement Information
>
2.7 V, V
SKD2
SKD3
SK1
SK2
SK3
MAX
MAX
OL
<
or differential channel-to-channel skew is defined as the magnitude difference in the differential propagation delays between two driver channels on
or differential part-to-part skew is defined as |t
or pulse skew is defined as |t
or channel-to-channel skew is defined as the magnitude difference in the propagation delays between two receiver channels on the same device.
or part-to-part skew is defined as |t
generator input conditions: t
generator input conditions: t
0.25 V, all channels switching.
FIGURE 2. Driver Propagation Delay and Transition Time Test Circuit
OS
) is specified as magnitude only, minus sign indicates direction only.
r
r
= t
PHL
= t
f
<
f
− t
<
1 ns (0% to 100%), 50% duty cycle, 0 V to 3 V. Output Criteria: duty cycle = 45%/55%, V
PLH Max
PLH
1 ns (0% to 100%), 50% duty cycle, V
FIGURE 1. Driver V
|. It is the magnitude difference in the propagation delays between the positive going edge and the negative
(Continued)
− t
PLHD Max
PLH Min
− t
| or |t
DD
PLHD Min
PHL Max
and within 5˚C of each other within the operating temperature range.
OD
| or |t
4
and V
− t
O
PHLD Max
PHL Min
= 50 Ω, t
ID
OS
DD
= 200 mV, V
|. It is the difference between the minimum and maximum specified
and within 5˚C of each other within the operating temperature range.
Test Circuit
− t
r
PHLD Min
≤ 1 ns, and t
CM
|. It is the difference between the minimum and maximum
= 1.2 V . Output Criteria: duty cycle = 45%/55%, V
f
≤ 1 ns.
20161703
OD
>
250 mV, all channels
20161704
OH