isl55211 Intersil Corporation, isl55211 Datasheet - Page 17

• Manufacturer Part Number: isl55211
• Description: Wideband, Low Noise, Low Distortion, Fixed Gain, Differential Amplifier
• Manufacturer: Intersil Corporation

Layout Considerations
The ISL55211 pinout is organized to isolate signal I/O along one
axis of the package with ground, power and control pins on the
other axis. Ground and power should be planes coming into the
upper and lower sides of the package (see “Pin Configuration” on
page 2). The signal I/O should be laid out as tight as possible.
The ground pins and package backside metal contact should be
connected into a good ground plane. The power supply should
have both a large values electrolytic cap to ground, then a high
frequency ferrite beads, then 0.01µF SMD ceramic caps at the
supply pins. Some improvement in HD2 performance may be
experienced by placing and X2Y cap between the two Vs+ pins
and ground underneath the package on the board back side. This
is 3 terminal device that is included in the Evaluation board
layout.
Evaluation Board (Rev. C)
Test circuit 1 (Figure 29) is implemented on an Evaluation Board
available from Intersil. This board includes a number of optional
features that not populated as the board is delivered. The full
Evaluation circuit is shown in Figure 40 where unloaded
(optional) elements are shown in green.
The nominal supply voltage for the board and device is a single
3.3V supply. From this, the ISL55210, ISL55211 generates an
internal common mode voltage of approximately 1.2V. That
voltage can be overridden by populating the two resistors and
potentiometer shown as R
19
to R
17
21
above.
ISL55211
The primary test purpose for this board is to implement different
interstage differential passive filters intended for the ADC
interface along with the ADC input impedances. The board is
delivered with only the output R's loaded to give a 200Ω
differential load. This is done using the two 85Ω resistors as R9
and R
finally the two shunt elements R
Including the 50Ω measurement load on the output side of the
1:1 transformer reflecting in parallel with the two 35Ω resistors
takes the nominal AC shunt impedance to 71Ω||50Ω = 29.3Ω.
This adds to the two 85Ω series output elements to give a total
load across the amplifier outputs of 170Ω + 29.3Ω = 199.3Ω.
To test a particular ADC interface RLC filter and converter input
impedance, replace R
C
with the specified ADC differential input R. With these loaded,
the remaining resistive elements (R
hit a desired total parallel impedance to implement the desired
filter (must be < than the ADC input differential R since that sits
in parallel with any "external" elements) and achieve a 250Ω
source looking into each side of the tap point transformer.
This Evaluation board includes a user's manual showing a
number of example circuits and tested results and is available on
the Intersil web site on the ISL55211 Product Information Page.
10
and C
10
, then the 4 0Ω elements (R
11
with the specified ADC input capacitance and R
11
and R
12
13
with RF chip inductors, load
and R
24
10
, R
, R
25
14
12
, R
, R
set to 35.5Ω.
13
24
, R
, and R
14
) are set to
June 21, 2011
25
FN7868.0
) and
26