cs4228a Cirrus Logic, Inc., cs4228a Datasheet - Page 29
![no-image](/images/manufacturer_photos/0/1/142/cirrus_logic__inc__sml.jpg)
cs4228a
Manufacturer Part Number
cs4228a
Description
24-bit, 96 Khz Surround Sound Codec
Manufacturer
Cirrus Logic, Inc.
Datasheet
1.CS4228A.pdf
(32 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
cs4228a-KS
Manufacturer:
CRYSTAL
Quantity:
20 000
Part Number:
cs4228a-KSEP
Manufacturer:
CRYSTAL
Quantity:
20 000
Company:
Part Number:
cs4228a-KSR
Manufacturer:
CIRRUSLOG
Quantity:
480
Part Number:
cs4228a-KSZ
Manufacturer:
CIRRUS
Quantity:
20 000
Part Number:
cs4228aKSZ
Manufacturer:
CIRRUS
Quantity:
20 000
7. PARAMETER DEFINITIONS
Dynamic Range
Total Harmonic Distortion + Noise
Idle Channel Noise / Signal-to-Noise-Ratio
Total Harmonic Distortion (THD)
Interchannel Isolation
Frequency Response
Interchannel Gain Mismatch
The ratio of the full scale RMS value of the signal to the RMS sum of all other spectral
components over the specified bandwidth. Dynamic range is a signal-to-noise measurement
over the specified bandwidth made with a -60 dBFS signal. 60 dB is then added to the resulting
measurement to refer the measurement to full scale. This technique ensures that the distortion
components are below the noise level and do not effect the measurement. This measurement
technique has been accepted by the Audio Engineering Society, AES17-1991, and the
Electronic Industries Association of Japan, EIAJ CP-307.
The ratio of the RMS value of the signal to the RMS sum of all other spectral components over
the specified bandwidth (typically 20 Hz to 20 kHz), including distortion components.
Expressed in decibels. ADCs are measured at -1 dBFs as suggested in AES 17-1991 Annex A.
The ratio of the RMS analog output level with 1 kHz full scale digital input to the RMS analog
output level with all zeros into the digital input. Measured A-weighted over a 10 Hz to 20 kHz
bandwidth. Units in decibels. This specification has been standardized by the Audio
Engineering Society, AES17-1991, and referred to as Idle Channel Noise. This specification has
also been standardized by the Electronic Industries Association of Japan, EIAJ CP-307, and
referred to as Signal-to-Noise-Ratio.
THD is the ratio of the test signal amplitude to the RMS sum of all the in-band harmonics of
the test signal. Units in decibels.
A measure of crosstalk between channels. Measured for each channel at the converter's output
with no signal to the input under test and a full-scale signal applied to the other channel. Units
in decibels.
A measure of the amplitude response variation from 20 Hz to 20 kHz relative to the amplitude
response at 1 kHz. Units in decibels.
For the ADCs, the difference in input voltage that generates the full scale code for each
channel. For the DACs, the difference in output voltages for each channel with a full scale
digital input. Units are in decibels.
CS4228A
29