irm-h638t-tr2 Everlight Electronics Co., Ltd., irm-h638t-tr2 Datasheet - Page 9

• Manufacturer Part Number: irm-h638t-tr2
• Description: Infrared Remote-control Receiver Module
• Manufacturer: Everlight Electronics Co., Ltd.

Recommended Solder Profile
Notice:
Soldering Iron
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
Repairing
unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed
beforehand whether the characteristics of the Devices will or will not be damaged by repairing.
Everlight Electronics Co., Ltd.
Device No：DMO-0000008
(1) Reflow soldering should not be done more than two times.
(2) When soldering, do not put stress on the IRM-H6XXT/TR2 Series devices during heating.
(3) After soldering, do not warp the circuit board.
1~5°C/sec.
Repair should not be done after the Devices have been soldered. When repairing is
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3
120sec.Max.
180~200°C
Pre-heating
1~5°C/sec
EVERLIGHT ELECTRONICS CO.,LTD.
60sec. Max.
Above. 220°C
http:\\www.everlight.com
Prepared date：09 -26-2007
10sec Max.
260°C Max.
Rev 1
IRM-H6XXT/TR2
Prepared by：IBU_NPID2
Page: 9 of 9