tda8752b-03 NXP Semiconductors, tda8752b-03 Datasheet - Page 13

• Manufacturer Part Number: tda8752b-03
• Description: Tda8752b Triple High-speed Analog-to-digital Converter 110 Msps
• Manufacturer: NXP Semiconductors

Philips Semiconductors
9397 750 07338
Product specification
Fig 7. Fine gain correction for a coarse gain G
8.4 ADCs
8.5 ADC outputs
8.6 Phase-locked loop
(67 codes)
The ADCs are 8-bit with a maximum clock frequency of 110 Msps. The ADCs input
range is 1 V (p-p) full-scale. One out of range bit exists per channel (ROR, GOR and
BOR). It will be at logic 1 when the signal is out of range of the full-scale of the ADCs.
Pipeline delay in the ADCs is 1 clock cycle from sampling to data output.
The ADCs reference ladders regulators are integrated.
ADC outputs are straight binary. An output enable pin (OE; active LOW) enables the
output status between active and high-impedance (OE = HIGH) to be switched; it is
recommended to load the outputs with a 10 pF capacitive load. The timing must be
checked very carefully if the capacitive load is more than 10 pF.
The ADCs are clocked either by an internal PLL locked to the CKREF clock (all of the
PLL is on-chip except the loop filter capacitance) or by an external clock applied to
pin CKEXT. Selection is performed via the serial interface bus.
The reference clock (CKREF) range is between 15 and 280 kHz. Consequently, the
VCO minimum frequency is 12 MHz and the maximum frequency is 110 MHz. The
gain of the VCO part can be controlled via the serial interface, depending on the
frequency range to which the PLL is locked.
To increase the bandwidth of the PLL, the charge pump current, controlled by the
serial interface, must also be increased. The relationship between the frequency and
the current is given by the following equation:
register
coarse
f
value
n
=
----- -
2
1
output code
N COARSE
ADC
------------------------------------- -
C
Z
255
227
160
128
K
+
O
C
Rev. 03 — 21 July 2000
P
NCOARSE
I
P
DR
Triple high-speed Analog-to-Digital Converter 110 Msps
N FINE = 31
.
N FINE = 0
G (max)
G NCOARSE
G (min)
FCE473
V ref
© Philips Electronics N.V. 2000. All rights reserved.
TDA8752B
13 of 38
(1)