tda8588 NXP Semiconductors, tda8588 Datasheet - Page 13

• Manufacturer Part Number: tda8588
• Description: Tda8588j; Tda8588xj I2c-bus Controlled 4 X 50 Watt Power Amplifier And Multiple Voltage Regulator
• Manufacturer: NXP Semiconductors

Philips Semiconductors
Protection
All regulator and switch outputs are fully protected by
foldback current limiting against load dumps and
short-circuits; see Fig.6. During a load dump all regulator
outputs, except the output of regulator 2, will go low.
The power switches can withstand ‘loss-of-ground’. This
means that if pin GND becomes disconnected, the switch
is protected by automatically connecting its outputs to
ground.
2004 Feb 24
handbook, full pagewidth
I
amplifier and multiple voltage regulator
2
C-bus controlled 4
V O(REGn)
50 Watt power
Fig.6 Foldback current protection.
I sc
13
Temperature protection
If the junction temperature of a regulator becomes too
high, the amplifier(s) are switched off to prevent unwanted
noise signals being audible. A regulator junction
temperature that is too high is indicated by pin DIAG going
LOW and is also indicated by setting bit D6 in data byte 2.
If the junction temperature of the regulator continues to
rise and reaches the maximum temperature protection
level, all regulators and switches will be disabled except
regulator 2.
I limit
TDA8588J; TDA8588xJ
I O(REGn)
MDB513
Product specification