pca9635 NXP Semiconductors, pca9635 Datasheet - Page 2

• Manufacturer Part Number: pca9635
• Description: Pca9635 16-bit Fm I2c-bus Led Driver
• Manufacturer: NXP Semiconductors

NXP Semiconductors
2. Features
PCA9635_5
Product data sheet
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
16 LED drivers. Each output programmable at:
1 MHz Fast-mode Plus compatible I
on SDA output for driving high capacitive buses
256-step (8-bit) linear programmable brightness per LED output varying from fully off
(default) to maximum brightness using a 97 kHz PWM signal
256-step group brightness control allows general dimming (using a 190 Hz PWM
signal) from fully off to maximum brightness (default)
256-step group blinking with frequency programmable from 24 Hz to 10.73 s and duty
cycle from 0 % to 99.6 %
Sixteen totem-pole outputs (sink 25 mA and source 10 mA at 5 V) with software
programmable open-drain LED outputs selection (default at totem-pole). No input
function.
Output state change programmable on the Acknowledge or the STOP Command to
update outputs byte-by-byte or all at the same time (default to ‘Change on STOP’).
Active LOW Output Enable (OE) input pin. LED outputs programmable to logic 1,
logic 0 or ‘high-impedance’ (default at power-up) when OE is HIGH, thus allowing
hardware blinking and dimming of the LEDs.
7 hardware address pins allow 126 PCA9635 devices to be connected to the same
I
4 software programmable I
LED Sub Call addresses) allow groups of devices to be addressed at the same time in
any combination (for example, one register used for ‘All Call’ so that all the PCA9635s
on the I
three different addresses so that
same time in a group). Software enable and disable for I
Software Reset feature (SWRST Call) allows the device to be reset through the
I
Up to 126 possible hardware adjustable individual I
that each device can be programmed individually.
25 MHz internal oscillator requires no external components
Internal power-on reset
Noise filter on SDA/SCL inputs
Edge rate control on outputs
No glitch on power-up
Supports hot insertion
Low standby current
Operating power supply voltage range of 2.3 V to 5.5 V
5.5 V tolerant inputs
ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per
JESD22-A115 and 1000 V CDM per JESD22-C101
2
2
N
N
N
N
40 C to +85 C operation
C-bus
C-bus
Off
On
Programmable LED brightness
Programmable group dimming/blinking mixed with individual LED brightness
2
C-bus can be addressed at the same time and the second register used for
Rev. 05 — 22 March 2007
2
C-bus addresses (one LED Group Call address and three
1
3
2
of all devices on the bus can be addressed at the
C-bus interface with 30 mA high drive capability
2
C-bus addresses per device so
16-bit Fm+ I
2
C-bus address.
PCA9635
2
© NXP B.V. 2007. All rights reserved.
C-bus LED driver
2 of 34