adv7189b Analog Devices, Inc., adv7189b Datasheet - Page 62
![no-image](/images/no-image-200.jpg)
adv7189b
Manufacturer Part Number
adv7189b
Description
Multiformat Sdtv Video Decoder
Manufacturer
Analog Devices, Inc.
Datasheet
1.ADV7189B.pdf
(104 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
adv7189bBSTZ
Manufacturer:
ELM
Quantity:
1 001
Company:
Part Number:
adv7189bBSTZ
Manufacturer:
Analog Devices Inc
Quantity:
10 000
Company:
Part Number:
adv7189bKSTZ
Manufacturer:
INVENSENS
Quantity:
21 500
Company:
Part Number:
adv7189bKSTZ
Manufacturer:
Analog Devices Inc
Quantity:
10 000
ADV7189B
REGISTER ACCESSES
The MPU can write to or read from most of the ADV7189B’s
registers, excepting the registers that are read-only or write-
only. The subaddress register determines which register the next
read or write operation accesses. All communications with the
part through the bus start with an access to the subaddress
register. Then, a read/write operation is performed from/to the
target address, which then increments to the next address until
a stop command on the bus is performed.
REGISTER PROGRAMMING
This section describes the configuration of each register. The
communications register is an 8-bit, write-only register. After
the part has been accessed over the bus and a read/write opera-
tion is selected, the subaddress is set up. The subaddress register
determines to/from which register the operation takes place.
T able 82 lists the various operations under the control of the
2 5 8 H
Subaddress register for the control port.
Register Select (SR7–SR0)
These bits are set up to point to the required starting address.
Rev. B | Page 62 of 104
I
An I
and is therefore distributed over two or more I
example, HSB[11:0].
When such a parameter is changed using two or more I
operations, the parameter can hold an invalid value for the time
between the first I
completed. In other words, the top bits of the parameter can
already hold the new value while the remaining bits of the
parameter still hold the previous value.
To avoid this problem, the I
updated bits of the parameter in local memory; all bits of the
parameter are updated together once the last register write
operation has completed.
The correct operation of the I
following:
x
x
2
C SEQUENCER
2
All I
written to in order of ascending addresses. For example, for
HSB[10:0], write to Address 0x34 first followed by 0x35.
No other I
writes for the sequence. For example, for HSB[10:0], write
to Address 0x34 first immediately followed by 0x35.
C sequencer is used when a parameter exceeds eight bits,
2
C registers for the parameter in question must be
2
C taking place between the two (or more) I
2
C being completed and the last I
2
C sequencer holds the already
2
C sequencer relies on the
2
C registers, for
2
C being
2
C write
2
C