xe8802 Semtech Corporation, xe8802 Datasheet - Page 102

• Manufacturer Part Number: xe8802
• Description: Data Acquisition Soc With 16+10 Bit Zoomingadc? Embedded Risc Controller And Lcd Driver
• Manufacturer: Semtech Corporation

15.7 Interrupts or polling
In receive mode, there are two possibilities to detect condition 1 or 2: the detection of the condition can generate
an interrupt or the registers can be polled (reading and checking the RegUsrtCond1 and RegUsrtCond2 registers
for the status of USRT communication).
15.8 Function description
The bit UsrtEnable in RegUsrtCtrl is used to enable the USRT interface and controls the PB[4] and PB[5] pins.
This bit puts these two port B lines in the open drain configuration requested to use the USRT interface.
If no external pull-ups are added on PB[4] and PB[5], the user can activate internal pull-ups by setting PBPullup[4]
and PBPullup[5] in RegPBPullup.
The bits UsrtEnWaitS0, UsrtEnWaitCond1, UsrtWaitS0 in RegUsrtCtrl are used for transmitter/receiver control
of USRT interface.
Figure 15-3 shows the unconditional clock stretching function which is enabled by setting UsrtEnWaitS0.
When UsrtEnWaitS0 is 1, the S0 line will be maintained at 0 after its falling edge (clock stretching). UsrtWaitS0 is
then set to 1, indicating that the S0 line is forced low. One can release S0 by writing to the RegUsrtBufferS1
register.
The same can be done in combination with condition 1 detection by setting the UsrtEnWaitCond1 bit. Figure 15-4
shows the conditional clock stretching function, which is enabled by setting UsrtEnWaitCond1.
© Semtech 2006
S0
UsrtWaitS0
write Reg UsrtBufferS1
Figure 15-3: S0 Stretching (UsrtEnWaitS0=1)
XE8802 Sensing Machine Data Acquisition MCU
15-5
with ZoomingADC™ and LCD driver
www.semtech.com