mpc8568e Freescale Semiconductor, Inc, mpc8568e Datasheet - Page 78
![no-image](/images/manufacturer_photos/0/2/263/freescale_semiconductor__inc_sml.jpg)
mpc8568e
Manufacturer Part Number
mpc8568e
Description
Mpc8568e Powerquicc Iii Processor
Manufacturer
Freescale Semiconductor, Inc
Datasheet
1.MPC8568E.pdf
(140 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
mpc8568eCVTAQGG
Manufacturer:
FREESCALE
Quantity:
310
Company:
Part Number:
mpc8568eCVTAQGG
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Company:
Part Number:
mpc8568ePXAQGG
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Company:
Part Number:
mpc8568eVTAQGG
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Company:
Part Number:
mpc8568eVTAUJJ
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Serial RapidIO
Figure 51. Compliance Test/Measurement Load
15 Serial RapidIO
This section describes the DC and AC electrical specifications for the RapidIO interface of the
MPC8568E, for the LP-Serial physical layer. The electrical specifications cover both single and
multiple-lane links. Two transmitters (short run and long run) and a single receiver are specified for each
of three baud rates, 1.25, 2.50, and 3.125 GBaud.
Two transmitter specifications allow for solutions ranging from simple board-to-board interconnect to
driving two connectors across a backplane. A single receiver specification is given that will accept signals
from both the short run and long run transmitter specifications.
The short run transmitter should be used mainly for chip-to-chip connections on either the same printed
circuit board or across a single connector. This covers the case where connections are made to a mezzanine
(daughter) card. The minimum swings of the short run specification reduce the overall power used by the
transceivers.
The long run transmitter specifications use larger voltage swings that are capable of driving signals across
backplanes. This allows a user to drive signals across two connectors and a backplane. The specifications
allow a distance of at least 50 cm at all baud rates.
All unit intervals are specified with a tolerance of +/– 100 ppm. The worst case frequency difference
between any transmit and receive clock will be 200 ppm.
To ensure interoperability between drivers and receivers of different vendors and technologies, AC
coupling at the receiver input must be used.
15.1
DC Requirements for Serial RapidIO SD_REF_CLK and
SD_REF_CLK
For more information, see
Section 13.2, “SerDes Reference Clocks.”
MPC8568E/MPC8567E PowerQUICC III™ Integrated Processor Hardware Specifications, Rev. 0
78
Freescale Semiconductor