v23836-c18-r363 Finisar Corporation., v23836-c18-r363 Datasheet - Page 4

• Manufacturer Part Number: v23836-c18-r363
• Description: Product Specification 1x9 Rohs Compliant Transceiver With Duplex Sc Receptacle Single Mode 1310 Nm 21 Km Sonet Oc-3/sdh Stm-1
• Manufacturer: Finisar Corporation.

V23836-C18-R363 Product Specification – October 2006
FUNCTIONAL DESCRIPTION
This transceiver is designed to transmit serial data via single mode fiber.
Figure 2 Functional Diagram
The receiver component converts the optical serial data into PECL compatible electrical
data (RD+ and RD–). The Signal Detect (SD, active high) shows whether optical data
1)
is present
.
The transmitter converts electrical PECL compatible serial data (TD+ and TD–) into
optical serial data.
The transmitter contains a laser driver circuit that drives the modulation and bias
currentof the laser diode. The currents are controlled by a power control circuit to
guarantee constant output power of the laser over temperature and aging.
The power control uses the output of the monitor PIN diode (mechanically built into the
laser coupling unit) as a controlling signal, to prevent the laser power from exceeding the
operating limits.
Single fault condition is ensured by means of an integrated automatic shutdown circuit
that disables the laser when it detects transmitter failures or when V
is too high. A reset
CC
is only possible by turning the power off, and then on again.
Notes:
1) We recommend to switch off the transmitter supply (V
Tx) if no transmitter input data is applied
CC
© Finisar Corporation October 2006 Rev. A Preliminary Data
4