at27c020-90pa ATMEL Corporation, at27c020-90pa Datasheet - Page 9
at27c020-90pa
Manufacturer Part Number
at27c020-90pa
Description
2-megabit 256k X 8 Otp Eprom
Manufacturer
ATMEL Corporation
Datasheet
1.AT27C020-90PA.pdf
(14 pages)
18. Rapid Programming Algorithm
0570G–EPROM–12/07
A 100 µs PGM pulse width is used to program. The address is set to the first location. V
raised to 6.5V and V
PGM pulse without verification. Then a verification/reprogramming loop is executed for each
address. In the event a byte fails to pass verification, up to 10 successive 100 µs pulses are
applied with a verification after each pulse. If the byte fails to verify after 10 pulses have been
applied, the part is considered failed. After the byte verifies properly, the next address is
selected until all have been checked. V
are read again and compared with the original data to determine if the device passes or fails.
PP
is raised to 13.0V. Each address is first programmed with one 100 µs
PP
is then lowered to 5.0V and V
CC
AT27C020
to 5.0V. All bytes
CC
is
9