s-93c46b Seiko Instruments Inc., s-93c46b Datasheet - Page 14

• Manufacturer Part Number: s-93c46b
• Description: Cmos Serial E2prom
• Manufacturer: Seiko Instruments Inc.

14
CMOS SERIAL E
S-93C46B/56B/66B
4. Writing (WRITE, ERASE, WRAL, ERAL)
Caution 1. Input a low level to the DI pin during a verify operation.
A write operation includes four write instructions: data write (WRITE), data erase (ERASE), chip write
(WRAL), and chip erase (ERAL).
A write instruction (WRITE, ERASE, WRAL, ERAL) starts a write operation to the memory cell when a
low level is input to CS after a specified number of clocks have been input. The SK and DI inputs are
invalid during the write period, so do not input an instruction.
Input an instruction while the output status of the DO pin is high or high impedance (Hi-Z).
A write operation is valid only in program enable mode (refer to “ 5. Write enable (EWEN) and write
disable (EWDS) ”).
4. 1 Verify operation
A write operation executed by any instruction is completed within 8 ms (write time t
ms), so if the completion of the write operation is recognized, the write cycle can be minimized. A
sequential operation to confirm the status of a write operation is called a verify operation.
(1) Operation
(2) Operation example
2. If a high level is input to the DI pin at the rise of SK when the output status of the DO
After the write operation has started (CS = low), the status of the write operation can be verified
by confirming the output status of the DO pin by inputting a high level to CS again. This
sequence is called a verify operation, and the period that a high level is input to the CS pin after
the write operation has started is called the verify operation period.
The relationship between the output status of the DO pin and the write operation during the
verify operation period is as follows.
• DO pin = low: Writing in progress (busy)
• DO pin = high: Writing completed (ready)
There are two methods to perform a verify operation: Waiting for a change in the output status
of the DO pin while keeping CS high, or suspending the verify operation (CS = low) once and
then performing it again to verify the output status of the DO pin. The latter method allows the
CPU to perform other processing during the wait period, allowing an efficient system to be
designed.
pin is high, the S-93C46B/56B/66B latches the instruction assuming that a start bit has
been input. In this case, note that the DO pin immediately enters a high-impedance
(Hi-Z) state.
2
PROM
Seiko Instruments Inc.
PR
Rev.4.3
: typically 4
_00