lm73cimkx-1 National Semiconductor Corporation, lm73cimkx-1 Datasheet - Page 6

• Manufacturer Part Number: lm73cimkx-1
• Description: 2.7v, Sot-23, 11-to-14 Bit Digital Temperature Sensor With 2-wire Interface
• Manufacturer: National Semiconductor Corporation

www.national.com
Note 2: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. DC and AC electrical specifications do not apply when operating
the device beyond its rated operating conditions.
Note 3: When the input voltage (V
Note 4: Reflow temperature profiles are different for lead-free and non-lead-free packages.
Note 5: Human body model, 100 pF discharged through a 1.5 kΩ resistor. Machine model, 200 pF discharged directly into each pin.
Note 6: Typicals are at T
Note 7: Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Note 8: Local temperature accuracy does not include the effects of self-heating. The rise in temperature due to self-heating is the product of the internal power
dissipation of the LM73 and the thermal resistance.
Note 9: This specification is provided only to indicate how often temperature data is updated. The LM73 can be read at any time without regard to conversion state
(and will yield last conversion result).
Note 10: The output fall time is measured from (V
Note 11: Holding the SMBDAT and/or SMBCLK lines Low for a time interval greater than t
and SMBCLK pins to a high impedance state.
Note 12: Represents the time from V
temperature conversion time, valid temperature will be available in the Temperature Register.
Note 13: A write to an invalid pointer address is not allowed. If the master writes an invalid address to the Pointer Register, (1) the LM73 will not acknowledge the
address and (2) the Pointer Register will continue to contain the last value stored in it.
A
= 25˚C and represent most likely parametric norm.
I
) at any pin exceeds the power supplies (V
DD
reaching the power-on-reset level to the LM73 communications being functional. After an additional time equal to one
IL;MAX
- 0.15V) to (V
SMBus Communication
IH;MIN
+ 0.15V).
I
<
6
GND or V
TIMEOUT
I
>
V
DD
), the current at that pin should be limited to 5 mA.
will reset the LM73’s SMBus state machine, setting SMBDAT
20147809