W83627G Winbond Electronics Corp America, W83627G Datasheet - Page 43

• Manufacturer Part Number: W83627G
• Description: LPC Interface I/O plus Game Port, MIDI Port, Pb-free package
• Manufacturer: Winbond Electronics Corp America

7.5.3
The W83627HF temperature sensor 1 SMI# interrupt has two modes
（1）Comparator Interrupt Mode
（2）Two-Times Interrupt Mode
Setting the T
to the Comparator Interrupt Mode. Temperature exceeds T
an interrupt and this interrupt will be reset by reading all the Interrupt Status Register. Once an in-
terrupt event has occurred by exceeding T
T
has occurred by exceeding T
will continue to occur in this manner until the temperature goes below T
Setting the THYST lower than TO will set temperature sensor 1 SMI# to the Two-Times Interrupt
Mode. Temperature exceeding TO causes an interrupt and then temperature going below THYST
will also cause an interrupt if the previous interrupt has been reset by reading all the interrupt
Status Register. Once an interrupt event has occurred by exceeding TO, then reset, if the tem-
perature remains above the THYST, the interrupt will not occur. （See Figure 8.9）
O
Temperature 1 SMI# modes
, the interrupt will occur again when the next conversion has completed. If an interrupt event
HYST
（Temperature Hysteresis） limit to 127°C will set temperature sensor 1 SMI#
Figure. 8.8 Temperature 1 SMI# Comparator Interrupt Mode
Figure. 8.9 Temperature 1 SMI# Two-Times Interrupt Mode
O
and not reset, the interrupts will not occur again. The interrupts
O
- 39 -
, then reset, if the temperature remains above the
O
W83627HF/ F/ HG/ G
Publication Release Date: June 09, 2006
（Over Temperature） Limit causes
O
. （See Figure 8.8 ）
Revision 2.27