tc94a09f TOSHIBA Semiconductor CORPORATION, tc94a09f Datasheet - Page 11

• Manufacturer Part Number: tc94a09f
• Description: Single-chip Cd Processor With Built-in Controller
• Manufacturer: TOSHIBA Semiconductor CORPORATION

Number
Pin
91
92
Symbol
HOLD
INTR
Hold mode control
External interrupt
Pin Name
input
input
Input pin used to request or release hold state.
Normally, the pin is used for inputting the CD
mode selection signal or battery detection
signal.
Halt states are Clock Stop mode (crystal
oscillator stops oscillation) and Wait mode
(CPU stops). The modes are entered using the
CKSTP and WAIT instructions.
By program, Clock Stop mode can be entered
by detection of Low level on the HOLD pin or
by forced execution. Clock Stop mode can be
released by detection of High level on the
Executing the CKSTP instruction stops the
clock generator and the CPU, entering memory
backup state. During memory backup state,
current dissipation becomes low (1 mA or
below). The display output and CMOS output
port automatically become Low level. The
N-channel open drain output becomes off.
Regardless of the HOLD pin input state, Wait
mode is executed and current dissipation
becomes low. Crystal oscillator only on or CPU
operation suspended can be programmed.
When the crystal oscillator only is on, all
displays are at Low level. The other pins are in
hold state. When CPU operation is suspended,
all states are held except that the CPU is
suspended. Wait mode is released by a change
of the HOLD pin input.
(Note) For Backup mode, use the oscillator
External interrupt input pin.
When interrupts are enabled and a pulse of
1.11 to 3.33 ms or more (13.3 to 40 ms when the
75 kHz clock is used) is input to this pin, an
interrupt is generated and the program jumps to
address 1. Input logic and rising/falling edge
can be individually selected for interrupt inputs.
The internal 8-bit timer clock can be selected
for interrupt inputs. Interrupts can be generated
(address 3) by pulse count or the count value.
Interrupt inputs are Schmidt inputs. The pin can
be used as an input port for inputs such as
remote control signals.
HOLD pin or change in the HOLD pin input.
connected to the MXO and MXI pins.
Turn off the V
CD), and enter Backup mode.
Function and Operation
11
DD
pin (power supply for
Remarks
TC94A09F
2001-10-15
MV
DD