atmega169v ATMEL Corporation, atmega169v Datasheet - Page 24

no-image

atmega169v

Manufacturer Part Number
atmega169v
Description
Atmega169 8-bit With 16k Bytes Of In-system Programmable Flash
Manufacturer
ATMEL Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
atmega169v-8AI
Manufacturer:
Atmel
Quantity:
10 000
Part Number:
atmega169v-8AI SL709
Manufacturer:
Atmel
Quantity:
10 000
Part Number:
atmega169v-8AI SL710
Manufacturer:
Atmel
Quantity:
10 000
Part Number:
atmega169v-8AU
Manufacturer:
Atmel
Quantity:
10 000
Changes from Rev.
2514C-11/02 to Rev.
2514D-01/03
24
ATmega169/V
5. Updated the “Ordering Information” on page 14 to include the new speed
1. Added TCK frequency limit in “Programming via the JTAG Interface” on page
2. Added Chip Erase as a first step in “Programming the Flash” on page 294 and
3. Added the section “Unconnected Pins” on page 60.
4. Added tips on how to disable the OCD system in “On-chip Debug System” on
5. Corrected interrupt addresses. ADC and ANA_COMP had swapped places.
6. Improved the table in “SPI Timing Characteristics” on page 300 and removed
7. Changed “will be ignored” to “must be written to zero” for unused Z-pointer
8. Corrected “LCD Frame Complete” to “LCD Start of Frame” in the LCDCRA
9. Changed OUT to STS and IN to LDS in USI code examples, and corrected
10. Removed TOSKON and TOSCK from Table 103 on page 238, and g10 and g20
11. Changed from 4 to 16 MIPS and MHz in the device Features list.
12. Corrected Port A to Port F in “AVCC” on page 6 under “Pin Descriptions” on
13. Corrected 230.4 Mbps to 230.4 kbps in “Examples of Baud Rate Setting” on
14. Corrected placing of falling and rising XCK edges in Table 78, “UCPOL Bit
15. Removed reference to Multipurpose Oscillator Application Note, which does
16. Corrected Number of Calibrated RC Oscillator Cycles in Table 1 on page 19
17. Various minor Timer1 corrections.
grade for ATmega169L and the new 16 MHz ATmega169.
284.
“Programming the EEPROM” on page 295.
page 35.
the table in “SPI Serial Programming Characteristics” on page 284.
bits in “Performing a Page Write” on page 259.
Register description.
f
cannot be used. LDS and STS take one more cycle when executed, so f
had to be changed accordingly.
from Figure 115 on page 240 and Table 105 on page 241, because these sig-
nals do not exist in boundary scan.
page 5.
page 174.
Settings,” on page 173.
not exist.
from 8,448 to 67,584.
SCKmax
. The USI I/O Registers are in the extended I/O space, so IN and OUT
2514PS–AVR–07/06
SCKmax

Related parts for atmega169v