cop888eb National Semiconductor Corporation, cop888eb Datasheet - Page 6

• Manufacturer Part Number: cop888eb
• Description: 8-bit Cmos Rom Based Microcontrollers With 8k Memory, Can Interface, 8-bit A/d, And Usart
• Manufacturer: National Semiconductor Corporation

DC Electrical Characteristics COP88xEB
(Continued)
Note 3: Supply current is measured after running 2000 cycles with a square wave CKI input, CKO open, inputs at V
or GND, and outputs open.
CC
Note 4: The HALT mode will stop CKI from oscillating in the Crystal configurations. Halt test conditions: All inputs tied to V
; Port C, G, E, F, L, M and N I/Os con-
CC
figured as outputs and programmed low; D outputs programmed high. Parameter refers to HALT mode entered via setting bit 7 of the Port G data register. Part will
pull up CKI during HALT in crystal clock mode. Both CAN main comparator and the CAN Wakeup comparator need to be disabled.
Note 5: HALT and IDLE current specifications assume CAN block comparators are disabled.
Note 6: Pins G6 and RESET are designed with a high voltage input network. These pins allow input voltages greater than V
and the pins will have sink current
CC
to V
when biased at voltages greater than V
(the pins do not have source current when biased at a voltage below V
). The effective resistance to V
is 750
CC
CC
CC
CC
(typical). These two pins will not latch up. The voltage at the pins must be limited to less than 14V.
Note 7: Condition and parameter valid only for part in HALT mode.
Note 8: Parameter characterized but not tested.
www.national.com
6