sc16is762ipw NXP Semiconductors, sc16is762ipw Datasheet - Page 35
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
sc16is762ipw
Manufacturer Part Number
sc16is762ipw
Description
Dual Uart With I2c-bus/spi Interface, 64 Bytes Of Transmit And Receive Fifos, Irda Sir Built-in Support
Manufacturer
NXP Semiconductors
Datasheet
1.SC16IS762IPW.pdf
(59 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
SC16IS762IPW
Manufacturer:
NXP
Quantity:
8 024
Company:
Part Number:
sc16is762ipw128
Manufacturer:
NXP Semiconductors
Quantity:
1 925
NXP Semiconductors
10. I
SC16IS752_SC16IS762_6
Product data sheet
2
C-bus operation
10.1 Data transfers
The two lines of the I
lines are connected to a positive supply via a pull-up resistor, and remain HIGH when the
bus is not busy. Each device is recognized by a unique address whether it is a
microcomputer, LCD driver, memory or keyboard interface and can operate as either a
transmitter or receiver, depending on the function of the device. A device generating a
message or data is a transmitter, and a device receiving the message or data is a
receiver. Obviously, a passive function like an LCD driver could only be a receiver, while a
microcontroller or a memory can both transmit and receive data.
One data bit is transferred during each clock pulse (see
line must remain stable during the HIGH period of the clock pulse in order to be valid.
Changes in the data line at this time will be interpreted as control signals. A HIGH-to-LOW
transition of the data line (SDA) while the clock signal (SCL) is HIGH indicates a START
condition, and a LOW-to-HIGH transition of the SDA while SCL is HIGH defines a STOP
condition (see
free again at a certain time interval after the STOP condition. The START and STOP
conditions are always generated by the master.
The number of data bytes transferred between the START and STOP condition from
transmitter to receiver is not limited. Each byte, which must be eight bits long, is
transferred serially with the most significant bit first, and is followed by an acknowledge bit
(see
master. The device that acknowledges has to pull down the SDA line during the
acknowledge clock pulse, while the transmitting device releases this pulse (see
Figure
Fig 12. Bit transfer on the I
Fig 13. START and STOP conditions
Figure
SDA
SCL
15).
14). The clock pulse related to the acknowledge bit is generated by the
Figure
START condition
SDA
SCL
S
2
Rev. 06 — 19 December 2006
C-bus are a serial data line (SDA) and a serial clock line (SCL). Both
13). The bus is considered to be busy after the START condition and
Dual UART with I
2
C-bus
data valid
data line
stable;
2
SC16IS752/SC16IS762
C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
allowed
change
of data
Figure
STOP condition
12). The data on the SDA
mba607
P
© NXP B.V. 2006. All rights reserved.
mba608
SDA
SCL
35 of 59