wm9715l Wolfson Microelectronics plc, wm9715l Datasheet - Page 58

• Manufacturer Part Number: wm9715l
• Description: Ac?97 Audio And Touchpanel Codec
• Manufacturer: Wolfson Microelectronics plc

WM9715L
w
AC97 DATA AND CONTROL INTERFACE
INTERFACE PROTOCOL
The WM9715Lhas a single AC’97 interface for both data transfer and control. The AC-Link uses 5
wires:
•
•
•
•
•
Figure 16 AC-Link Interface (typical case with BITCLK generated by the AC97 codec)
The SDATAIN and SDATAOUT signals each carry 13 time-division multiplexed data streams (slots 0
to 12). A complete sequence of slots 0 to 12 is referred to as an AC-Link frame, and contains a total
of 256 bits. The frame rate is 48kHz. This makes it possible to simultaneously transmit and receive
multiple data streams (e.g. audio, touchpanel, AUXDAC, control) at sample rates up to 48kHz.
Detailed information can be found in the AC’97 (Revision 2.2) specification, which can be obtained at
http://www.intel.com/design/chipsets/audio/
Note:
SDATAOUT and SYNC must be held low for when RESETB is applied. These signals must be held
low for the entire duration of the RESETB pulse and especially during the low-to-high transition of
RESETB. If either is set high during reset the AC’97 device may enter test modes. Information
relating to this operation is available in the AC’97 specification or in Wolfson applications note
WAN-0104 available at www.wolfsonmicro.com.
SDATAIN (pin 8) carries data from the WM9715L to the controller
SDATAOUT (pin 5) carries data from the controller to the WM9715L
BITCLK (pin 6) is a clock, normally generated by the WM9715L crystal oscillator and
supplied to the controller. However, BITCLK can also be passed to the WM9715L from
an off-chip generator.
SYNC is a synchronization signal generated by the controller and passed to the
WM9715L
RESETB resets the WM9715L to its default state
PD Rev 4.0 December 2007
Production Data
58