wm9713 Wolfson Microelectronics plc, wm9713 Datasheet - Page 125

• Manufacturer Part Number: wm9713
• Description: Ac?97 Audio + Touchpanel Codec
• Manufacturer: Wolfson Microelectronics plc

Pre-Production
DC COUPLED (CAPLESS) HEADPHONE OUTPUT
BTL LOUDSPEAKER OUTPUT
w
In the interest of saving board space and cost, it may be desirable to eliminate the 220µF DC
blocking capacitors. This can be achieved by using OUT3 as a headphone pseudo-ground, as shown
below.
Figure 39 Capless Headphone Output Circuit Diagram
As the OUT3 pin produces a DC voltage of AVDD/2, there is no DC offset between HPL/HPR and
OUT3, and therefore no DC blocking capacitors are required. However, this configuration has some
drawbacks:
The power consumption of the WM9713L is increased, due to the additional power
If the DC coupled output is connected to the line-in of a grounded piece of equipment, then
OUT3 cannot be used for another purpose
SPKL and SPKR can differentially drive a mono 8Ω loudspeaker as shown below.
Figure 40 Speaker Output Connection (INV = 1)
To drive out differentially one of the speaker outputs must be inverted using INV1 or INV2.
consumed in the OUT3 output buffer.
OUT3 becomes short-circuited. Although the built-in short circuit protection will prevent
any damage to the WM9713L, the audio signal will not be transmitted properly.
PP Rev 3.2 September 2008
WM9713L
125