wm8802scft/v Wolfgang Knap, wm8802scft/v Datasheet - Page 13

• Manufacturer Part Number: wm8802scft/v
• Description: Digital Audio Interface Transceiver
• Manufacturer: Wolfgang Knap

Product Preview
DESCRIPTION OF DEMODULATION FUNCTION
CLOCKS
w
The demodulation function operation settings are performed using RXOPR.
PLL (LPF)
The VCO (Voltage Controlled Oscillator) can be stopped if PLLOPR is set. Synchronization to
frequencies from 32kHz to 192kHz and RMCK of 4MHz to 25MHz can be selected.
The PLL clock frequency is selected with PLLSEL. For systems with an input data sampling
frequency of 105kHz or lower, the initial setting of 512fs is recommended. Since the system clock
RMCK output initial value is set to 1/2 of PLLSEL, the RMCK output is 256fs when a PLL clock
frequency of 512fs is used.
For systems with an input data sampling frequency higher than 105kHz, the PLL clock frequency
should be set to 256fs. RMCK will be 128fs if PRSEL0 is set to 1 and the same initial output setting
(i.e. 256fs) is used,
LPF is a PLL loop filter pin. Resistances and capacitances should be selected in accordance with
the frequency of the PLLSEL system clock. The PLLSEL setting should be set prior to bi-phase data
input since PLLSEL switching involves a change in LPF loop filter constant.
Figure 5 Loop Filter Configuration
Table 6 Loop Filter Component Values
PLLCK1
0
0
1
1
C
R
0
0
LPF
C
1
PLLCK0
0
1
0
1
150 Ω
220 Ω
R0
0.047µF
0.068µF
C0
PP Rev 1.1 April 2004
WM8802
0.0068µF
0.0047µF
C1
13